Computer System
Every Computer System has the following three basic components:

a) Input Unit
b) Central Processing Unit
c) Output Unit

1. Input Unit
This unit helps user to enter data and commands into a computer system.
Input unit converts data and instructions into binary form and directs into computer.

2. Central Processing Unit (CPU)
CPU is the brain of the computer.
CPU processes the data according to the instructions provided.
CPU is on a single chip called as Processor

The CPU has following units :
Arithmetic Logic Unit
Control Unit
Memory Registers

3. Output Unit
Output unit conveys data/information to users.
It converts the processed data into a format which human can understand.

Memory
Computer memory, device that is used to store data or programs (sequences of instructions) on a temporary or permanent basis for use in an electronic digital computer.

Memory is of two types :
1. Primary Memory or Internal Memory
2. Secondary Memory or External Memory

1. Primary Memory
a. RAM (Random Access Memory)

* It is the main memory or the working memory of the computer system.
* It is read-write memory.
* On starting the computer, the operating system is loaded in RAM.
* It is temporary memory.
* The information stored in RAM is lost on switching OFF Power supply.
* Therefore It is also called Volatile Memory.

b. ROM (Read Only Memory)

* It contains the programs (BIOS) needed to start a PC, which is essential for boot-up.
* It is permanent memory and read only.
* The ROM is used by Operating system to perform major input/output tasks.
* There are numerous ROM chips located on the motherboard and a few on expansion boards.
* The chips are essential for the basic input/output system (BIOS), boot up, reading and writing to peripheral devices, * basic data management and the software for basic processes for certain utilities.

*** Because ROM cannot be changed and is read-only, it is mainly used for firmware.***
Firmware

It is software programs or sets of instructions that are embedded into a hardware device.
It supplies the needed instructions on how a device communicates with various hardware components.
Firmware is referred to as semi-permanent because it does not change unless it is updated.
Firmware includes BIOS, erasable programmable ROM (EPROM) and the ROM configurations for software.

REGISTERS AND CACHE MEMORY
Registers are high-speed sttorage locations inside the microprocessor. Designed to be accessed at much higher speed than conventional memory. Registers are classified according to the functions they perform.

Cache memory is an extremely fast memory type that acts as a buffer between RAM and the CPU.
It holds frequently requested data and instructions so that they are immediately available to the CPU when needed.
Cache memory is used to reduce the average time to access data from the Main memory.

2. Secondary Memory
MAGNETIC TAPES
A magnetic tape drive is a storage device that makes use of magnetic tape as a medium for storage.
It uses a long strip of narrow plastic film with tapes of thin magnetizable coating.

MAGNETIC DISKS
A magnetic disk is a storage device that uses a magnetization process to read, write, rewrite and access data.
It is covered with a magnetic coating and stores data in the form of tracks, spots and sectors.
Hard disks, zip disks and floppy disks are common examples of magnetic disks.

HARD DISK DRIVE (HDD)

A hard disk drive (HDD), hard disk, hard drive, or fixed disk is an electro-mechanical data storage de

	Created by Dhuka Abid over 6 years ago

sasasasasasasasasasa