Brian Gamble
Quiz by , created more than 1 year ago

Final / Review ICND 1 Quiz on DIKTA ICND 1 Ch 8, created by Brian Gamble on 25/02/2016.

29
0
0
Brian Gamble
Created by Brian Gamble about 8 years ago
Close

DIKTA ICND 1 Ch 8

Question 1 of 7

1

Imagine that you have configured the enable secret command, followed by the enable password command, from the console. You log out of the switch and log back in at the console. Which command defines the password that you had to enter to access privileged mode?

Select one of the following:

  • enable password

  • enable secret

  • Neither

  • The password command, if it’s configured

Explanation

Question 2 of 7

1

An engineer had formerly configured a Cisco 2960 switch to allow Telnet access so that the switch expected a password of mypassword from the Telnet user. The engineer then changed the configuration to support Secure Shell. Which of the following commands could have been part of the new configuration? (Choose two answers.)

Select one or more of the following:

  • A username name password password vty mode sub command

  • A username name password password global configuration command

  • A login local vty mode sub command

  • A transport input ssh global configuration command

Explanation

Question 3 of 7

1

The following command was copied and pasted into configuration mode when a user was telnetted into a Cisco switch:

banner login this is the login banner

Which of the following is true about what occurs the next time a user logs in from
the console?

Select one of the following:

  • No banner text is displayed.

  • The banner text “his is” is displayed.

  • The banner text “this is the login banner” is displayed.

  • The banner text “Login banner configured, no text defined” is displayed.

Explanation

Question 4 of 7

1

Which of the following is required when configuring port security with sticky learning?

Select one of the following:

  • Setting the maximum number of allowed MAC addresses on the interface with
    the switchport port-security maximum interface subcommand

  • Enabling port security with the switchport port-security interface subcommand

  • Defining the specific allowed MAC addresses using the switchport port-security
    mac-address interface subcommand

  • All the other answers list required commands

Explanation

Question 5 of 7

1

An engineer’s desktop PC connects to a switch at the main site. A router at the main site connects to each branch office through a serial link, with one small router and switch at each branch. Which of the following commands must be configured on the branch office switches, in the listed configuration mode, to allow the engineer to telnet to the branch office switches? (Choose three answers.)

Select one or more of the following:

  • The ip address command in interface configuration mode

  • The ip address command in global configuration mode

  • The ip default-gateway command in VLAN configuration mode

  • The ip default-gateway command in global configuration mode

  • The password command in console line configuration mode

  • The password command in vty line configuration mode

Explanation

Question 6 of 7

1

Which of the following describes a way to disable IEEE standard autonegotiation on a 10/100 port on a Cisco switch?

Select one of the following:

  • Configure the negotiate disable interface subcommand

  • Configure the no negotiate interface subcommand

  • Configure the speed 100 interface subcommand

  • Configure the duplex half interface subcommand

  • Configure the duplex full interface subcommand

  • Configure the speed 100 and duplex full interface subcommands

Explanation

Question 7 of 7

1

In which of the following modes of the CLI could you configure the duplex setting for interface Fast Ethernet 0/5?

Select one of the following:

  • User mode

  • Enable mode

  • Global configuration mode

  • VLAN mode

  • Interface configuration mode

Explanation

Previous
Next