QEI Practice Test

The maximum supply voltage shall not exceed ______ between conductors unless otherwise permitted.

The first edition of the 17.1 code was published in what year?

What Section of NFPA 70 pertains to Elevators, Dumbwaiters, Escalators, Moving Walks, Platform Lifts, and Stairway Chairlifts?

Each 125-volt, single-phase, 15- and 20-ampere receptacle installed in pits, in hoistways, on elevator car tops, and in escalator and moving walk wellways shall be of the _____________________________type.

Per NFPA 70, Ground means:

To whom is the maintenance control program required to be accessible?

Final Terminal Stopping Devices for Screw-Elevators shall be provided for elevators having a rated speed exceeding:

Which of the following should you do when operating a mainline power disconnect switch?

What article in NEC 2014 covers hazardous (classified ) locations?

For existing elevator interiors, what is the minimum number of lamps required for car illumination?

What is required of a maintenance control program?

The audible and visual equipment such as chimes, gongs, lights and displays that convey information to the user is defined as what?

When performing maintenance on an escalator, what is required if the escalator comb has two adjacent teeth missing?

Speed governors for passenger car safeties shall be set to trip at a car speed of what?

When jumpers are used during maintenance, repairs, or testing, all jumpers shall be ______________ and the equipment ______________ prior to returning it to service.

The lower portion of a platform guard shall be bent back at an angle of not less than __________degrees nor more than _______ degrees from the horizontal.

Every elevator shall be provided with a _________________ and a _________________ permanently and securely attached.

Hand elevator suspension means shall consist of not less than ______ wire ropes or chains.

____________ shall be provided in the entrance assembly to prevent hangers from overrunning the end of the track.

What type of floor shall be provided at the top of the hoistway where a machine room or control room is located above the hoistway.