12097647
Descripción
Test por Kaitlyn Hickey, actualizado hace más de 1 año
|
Creado por Kaitlyn Hickey
hace alrededor de 6 años
|
|
Pregunta 1
Pregunta
Which section of the CEC deals with installation of heating units
Respuesta
-
Section 12
-
Section 16
-
Section 46
-
Section 62
Pregunta 2
Pregunta
A BTU is
Respuesta
-
Heat energy required to raise the temperature of a litre of water 1F
-
Heat energy required to raise the temperature of a pound of water 1F
-
Heat energy required to raise the temperature of a pound of water 1C
-
Heat energy required to raise the temperature of a litre of water 1C
Pregunta 3
Pregunta
Heat transferred by electromagnetic wave motion by which we receive heat from the sun is through?
Respuesta
-
Conduction
-
Convection
-
Radiation
-
HVAC units
Pregunta 4
Pregunta
What is usually provided on the intake side of the fan in the return air system?
Respuesta
-
Supply plenum
-
Power supply filter
-
Filter
-
Flue or stack
Pregunta 5
Pregunta
A schematic diagram is used to
Respuesta
-
Demonstrate how electrical circuits work
-
Show the relative physical location of components
-
To wire a circuit
-
To find a control device
Pregunta 6
Pregunta
The function of the refrigeration cycle is to
Respuesta
-
Removes heat from low temperature body and delivers it to a high temperature body
-
Removes heat from a high temperature body and delivers it to a low temperature body
-
Rejects energy to low temperature body
-
None of the above
Pregunta 7
Pregunta
Which section of the CEC covers rules relating to disconnect switches for furnaces?
Respuesta
-
Section 12
-
Section 16
-
Section 28
-
Section 62
Pregunta 8
Pregunta
Which part of the HVAC system is responsible for compressing the Freon
Respuesta
-
Compressor
-
Condenser
-
Evaporator
-
TX valve
Pregunta 9
Pregunta
This type of compressor is completely sealed inside a metal housing and is not serviceable
Respuesta
-
Hermetic
-
Reciprocating
-
Scroll
-
Semi-hermetic
Pregunta 10
Pregunta
What substance is used in a heat cycle to transfer heat from one area, and remove it to another
Respuesta
-
Refrigerant
-
Neon
-
Vapor
-
Xenon
Pregunta 11
Pregunta
A conventional condenser unit requires a liquid refrigerant which is also called?
Respuesta
-
Freon
-
Hydrogen
-
Helium
-
Carbon dioxide
Pregunta 12
Pregunta
Which component pushes the hot gas to the finned condenser coil in the outdoor side of the air conditioner
Respuesta
-
Control valve
-
Evaporator thermal expansion valve
-
The receiver
-
The compressor
Pregunta 13
Pregunta
Two different pressures exist in the refrigeration cycle. Two components that separate the high-pressure side from the low-pressure side are:
Respuesta
-
Compressor and TRX valve
-
Evaporator coil and TRX valve
-
Condenser coil and compressor
-
Compressor and receiver
Pregunta 14
Pregunta
In the cooling mode, what component is located inside the building?
Respuesta
-
The condenser coils
-
The 4 way reversing valve
-
The compressor
-
The evaporator
Pregunta 15
Pregunta
To go from cooling source in a heat pump, what is required?
Respuesta
-
TRX valve
-
4 way reversing valve
-
Double pole thermostat
-
A disconnect switch
Pregunta 16
Pregunta
The amount of heat added to the liquid to make it saturated and change states is called
Respuesta
-
Super heat
-
Heat energy
-
Latent heat
-
Transferred heat
Pregunta 17
Pregunta
Heat, that when added or removed, causes a change in temperature but not in state
Respuesta
-
Latent heat
-
Sensible heat
-
Low heat
-
Energy heat
Pregunta 18
Pregunta
Refrigerant lines are usually made from
Respuesta
-
Aluminum
-
Stainless steel
-
Copper
-
Either a or c
Pregunta 19
Pregunta
Which part of a cooling system absorbs heat from the air?
Respuesta
-
Condenser
-
Evaporator
-
Compressor
-
Accumulator
Pregunta 20
Pregunta
Why is it necessary to have a heating element in a heat pump?
Respuesta
-
To eliminate condenser freezing
-
To protect against high outside temperature
-
To protect against low outside temperature
-
To provide heat for the room
Pregunta 21
Pregunta
Which statement indicates an acceptable method of supplying power to a 65,000 BTU gas fired hot water furnace?
Respuesta
-
Supply furnace from basement lighting
-
Supply furnace from nearest receptacle
-
Supply furnace from smoke detector circuit
-
Supply from dedicated circuit
Pregunta 22
Pregunta
What describes heat transfer from one metal to another in a heating system?
Respuesta
-
Conduction
-
Radiation
-
Convection
-
Evaporator
Pregunta 23
Pregunta
What type of evaporator coil is used in a heat pump?
Respuesta
-
Fin tube
-
Helical tube
-
Plate tube
-
Air bay pass tube
Pregunta 24
Pregunta
What does a shop drawing show?
Respuesta
-
Cost of components
-
Elevation of components
-
Logical operation of components
-
Electrical rating of components
Pregunta 25
Pregunta
What if the minimum current rating for a disconnect serving a motor compressor?
Respuesta
-
100% of the rate load current
-
115% of the rated load current
-
125% of the RLC
-
140% of the RLC
Pregunta 26
Pregunta
A high limit control in a gas furnace control is switched with a fan limit control. What is the result?
Respuesta
-
The burner will not ignite
-
The fan will cycle on and off
-
The burner won’t turn off
-
The fan won’t run
Pregunta 27
Pregunta
Which calculation determines the size of the overload fuses for motor compressor appliances?
Respuesta
-
100% of the rated load current
-
115% of the rated load current
-
125% of the RLC
-
140% of the RLC
¿Quieres crear tus propios Tests gratis con GoConqr? Más información.