4728772
Descripción
Test por Brian Gamble, actualizado hace más de 1 año
|
Creado por Brian Gamble
hace alrededor de 8 años
|
|
Pregunta 1
Pregunta
Which of the following installation steps are typically required on a Cisco router, but not typically required on a Cisco switch? (Choose two answers.)
Respuesta
-
Connect Ethernet cables
-
Connect serial cables
-
Connect to the console port
-
Connect the power cable
-
Turn the on/off switch to “on”
Pregunta 2
Pregunta
Which of the following commands might you see associated with the router CLI, but not with the switch CLI?
Respuesta
-
The clock rate command
-
The ip address address mask command
-
The ip address dhcp command
-
The interface vlan 1command
Pregunta 3
Pregunta
You just bought two Cisco routers for use in a lab, connecting each router to a different LAN switch with their Fa0/0 interfaces. You also connected the two routers’ serial interfaces using a back-to-back cable. Which of the following steps are not required to be able to forward IPv4 packets on both routers’ interfaces? (Choose two answers.)
Respuesta
-
Configuring an IP address on each router’s Fast Ethernet and serial interfaces
-
Configuring the bandwidth command on one router’s serial interface
-
Configuring the clock rate command on one router’s serial interface
-
Setting the interface description on both the Fast Ethernet and serial interface of each router
Pregunta 4
Pregunta
The output of the show ip interface brief command on R1 lists interface status codes of “down” and “down” for interface Serial 0/0. Which of the following could be true?
Respuesta
-
The shutdown command is currently configured for that interface
-
R1’s serial interface has been configured to use Frame Relay, but the router on the other end of the serial link has been configured to use PPP.
-
R1’s serial interface does not have a serial cable installed.
-
Both routers have been cabled to a working serial link (CSU/DSUs included), but only one router has been configured with an IP address.
Pregunta 5
Pregunta
Which of the following commands do not list the IP address and mask of at least one interface? (Choose two answers.)
Respuesta
-
show running-config
-
show protocols type number
-
show ip interface brief
-
show interfaces
-
show version
Pregunta 6
Pregunta
Which of the following is different on the Cisco switch CLI as compared with the Cisco router CLI?
Respuesta
-
The commands used to configure simple password checking for the console
-
The number of IP addresses configured
-
The configuration of the device’s host name
-
The configuration of an interface description
¿Quieres crear tus propios Tests gratis con GoConqr? Más información.