What is 5w30 Oil used for?
What type of component show in the image?
Oil Filters are made of?
How do you tighten an Oil Filter when installing a new one?
Using an Oil Filter Wrench
Only tighten by hand
Using a Tightening Strap
Using a Torque Wrench
In what type of vehicle would a dry sump system be used?
What components are located in a sump?
Oil Pickup and Strainer
Oil Bypass Filter
The arrow on the filter shows?
The direction the filter needs to be located into the sump
The direction that the filter needs to be pulled to remove
The direction of flow of the oil
The arrow needs to face out of the engine
When reconnecting a battery which cable should you connect first?
It doesn’t matter which one is connected first
Connect both at the same time
The positive cable
The negative cable
What position should an automatic car be started in?
When topping up the coolant level you should top it up?
Level with the cap
When the engine is running hot
Slightly above the cool level
Never top up the coolant
What device connects at the arrow?
The substance being applied to the tyre wall is used to?
Inflate the tyre
Glue tyre to wheel rim
Help removal and refitting of tyre.
The image shows?
Spark plug gasket fitment
Spark plug tightening procedure
Spark gap checking
Glow plug fitment
When carrying out routine maintenance on a vehicle you discover that the engine oil is empty. What should you do?
The engine is meant to be empty of oil.
Top up the oil and complete the service but do not make a note on the jobcard
Top up the oil and complete the service and make a note on the jobcard
Speak to a technician supervisor or Service Manager before doing anything else
A 5W/21W bulb is used for?
Brake light & stop & tail lights
Fibre Optics operate by using?
Pulses of light
Carbon Fibre filaments
Four valve compression engine
Two valve compression engine
Four valve spark ignition engine
Two valve spark ignition engine
On a diesel car the following warning light is shown. What is a likely cause?
Petrol in the diesel fuel
Water in the fuel filter
Identify the component shown in the image.
Oil reserve tank
Identify what is being carried out in the image shown?
Wheel condition check
Tyre depth check
Tyre pressure check
Wheel bearing run out
Specifications for a vehicle’s maintenance systems (i.e. oil type) would NOT be found in the….?
Vehicle’s job card
Prior to carrying out work on a vehicle, the vehicle should be inspected for damage. What should happen if cosmetic damage is noticed?
Record it on a scrap bit of paper
Not recorded, as it is not required
Recorded on the job card
Highlighted on the vehicle
Brake pads and discs would be inspected on a service interval for which of the following?
Brake fluid leaks
Wear & Condition
Co-efficient of Friction
What is the test equipment in the image and what is its function?
Water Sampler - For checking the windscreen wash
Hygrometer - For testing the state of charge of a battery cell
Hydrometer - For testing the state of charge of a battery cell
Pressure tester - To check the state of the internal expansion tank
Feeler Gauge - Used to check ignition timing
Fan Gauge - Used to check ignition timing
Fan Gauge - Used to set a spark plug gap
Feeler Gauge - Used to set a spark plug gap
What is the device below and give an example of what it may be used to measure?
External Micrometer - Used to measure Piston head diameter
External Micrometer - Used to measure the thickness of brake pads
Internal Micrometer - Used to measure the thickness of brake pads
Internal Micrometer - Used to measure piston head diameter
Dial Test Indicator - Used to determine the thickness of a brake disk
Air Line - Used to regulate the pressure in the line
Dial Test Indicator - Used to check runout on brake disks
Drum Test Indicator - Used to measure the thickness of the brake drum.
What is the device in the image and what is it going to be used to check, in this instance?
Multimeter, in this case it is going to be used for check DC voltage
Multimeter, in this case it is going to be used for check AC voltage
Oscilicope, in this case it is going to be used for check DC voltage
Oscilicope, in this case it is going to be used for check AC voltage
What servicing should you do on a sealed car battery?
Replace the acid
Top up the water with distilled water
Check the indicator
Top up the water with bottled water
When the tyre has been worn down to the tread wear indicators what should you do?
The tyre can be used for another 10000 miles
They tyre is fine for another 6 months
The tyre is at the legal limit and should be replaced
The tyre is well above the limit
What type of glass in the car uses a plastic insert?
How will a side window react when it is broken
It will break into several shards
It will not shatter as it has a laminated insert
It will always shatter outwards, away from the car, for safety reasons.
It will shatter into lots of small chunks of glass
What is the unit of measurement for Voltage
Amps - A
Ohms - Ω
Watts - W
Volts - V
What unit of measure would you use to measure the resistance of a cable?
What is the unit of measure for electric current?
What is the current in a circuit that has a voltage of 18v and a resistance of 6ohms
What is the mechanic doing in the picture?
Draining the axle housing
Checking the level of the oil in the axle housing
Topping up the coolant level
Draining the coolant
The images shows…..
Wing protection cover
The initials ‘TWI’ on the side of a tyre stands for?
Tyre Wall Indicator
Tyre Wear Insulator
Tread Wear Indicator
Tread Wall Indicator
The legal limit for tyre tread is?
A mechanic can find details of work to be undertaken…
In the workshop manual
In the Owners Handbook
On the jobcard
On the specification sheet
If a car wheel alignment is in tolerance then…..
It is not okay to use
It is okay to use.
It requires a realignment
It requires rechecking
What is the use of the equipment in the image?
What fault is likely if the light in the image is lit on your dash?
Battery not charging
No electrical power to the vehicle
During an inspection on a vehicle braking system, it is necessary to compare the thickness of the original front disc with a new one. Using the technical data sheet shown, a front disc has a thickness of.....
A visual inspection procedure is used to check for....
the thickness of a selective spacer
the amount of bend on a drive shaft
scoring on a brake disc
the clearance between a camshaft lobe and follower
A tyre side wall has the marking 205/60/R/15/91/V. The letter R indicates the tyre...
is radial ply construction
is a re-grooved tyre
is a rolling resistance tyre
is a remoulded tyre.
The tool shown opposite is used to...
Check tread depths
Balance road wheels
Measure tyre pressures
Remove balance weights
If liquid from a battery is spilled onto paintwork, it should be...
Blown off with an air line
Covered with absorbent granules
Rinsed off with water immediately
Allowed to dry and then polished off.
Wheel nuts must not be over-tightened, otherwise the....
Threads will become weaker
Tyre pressure will have to be increased
Wheel will be incorrectly located
Assembly will become unbalanced