Which of the following is NOT a manufacturers-recommended scheduled service type?
Checks are to be made for leaks on a fuel system. One method of doing this is by using?
An emissions test
A visual check
Engine Code reader
A Naked Flame
The front wheel alignment of a vehicle is found to require adjustment. How should the adjustment be undertaken on a rack and pinion steering system?
By moving the torsion bar to the nearside or offside of the vehicle
By increasing the drop arm length
By adding additional shims to the ball joints
By adjusting the track rod length
Specific gravity of a cooling system anti-freeze should be inspected using?
Which one of the following may require adjusting as part of a routine service?
The type of oil filter show in the image is known as a replaceable….?
A fully sealed expansion tank is used to which of the following?
Check and drain a liquid cooling system
Clean the coolant of a liquid cooling system
Check and refill a liquid cooling system
Check the temperature of the coolant
To set a spark plug gap, which of the following is the measuring tool used?
Dial test indicator
What is the component shown in the image?
In-line fuel filter
In-tank fuel filter
Integrated fuel filter
When referring to tyre tread depth, what does the abbreviation TWI stand for?
Tyre Width Indicator
Tyre Wear Indicator
Tread Wide Indicator
Tread Wear Indicator
If the ABS light remains on, this warns the driver that the ABS system….?
Is functioning correctly
Has applied the breaks
Is not functioning correctly
Brake fluid requires changing
Drive belts should be inspected on a service interval for which of the following?
Wear and condition
Wear, clearance and elasticity
Brake lining and drums should be inspected on a service interval for which of the following?
Brake fluid leaks
Brake fluid level
Which of the following faults will not be indicated by a low brake fluid reservoir level?
Excessively worn brake pads
Over adjusted hand brake
External brake fluid leak
Internal brake fluid leak
Why is it important for a vehicle to be on a level surface when checking engine oil level?
Easy access to engine
Dip stick may show a high reading
Dip stick may show a low reading
Dip stick will show correct reading
If liquid from a battery is spilled onto paintwork, it should be....?
blown off with an air line
covered with absorbent granules
rinsed off with water immediately
allowed to dry and then polished off.
Which one of the following precautions should be taken when removing the pressure cap from the cooling system of a hot engine?
The cap must be released slowly with a rag placed over it
The engine must be running at a speed of less than 1000 rpm
A dust mask must be worn to prevent the harmful vapours being inhaled
A drain tray must be placed under the radiator and the cap removed quickly.
What is the minimum legal tread depth for a car tyre?
Wheel nuts must not be over-tightened, otherwise the
tyre pressure will have to be increased
wheel will be incorrectly located
threads will become weaker
assembly will become unbalanced.
During an inspection on a vehicle braking system, it is necessary to compare the thickness of the original front disc with a new one. Using the technical data sheet shown, a front disc has a thickness of
A visual inspection procedure is used to check for?
scoring on a brake disc
the thickness of a selective spacer
the amount of bend on a drive shaft
the clearance between a camshaft lobe and follower.
The most suitable method of measuring the thickness of a brake disc is by using a...?
dial test indicator
calliper and rule.
When fitting a replacement cartridge filter element to an engine lubrication system, it is important to...?
use a sealant on the sealing ring
put a sealant onto the mounting face
tighten up the cartridge using a filter strap
pour some engine oil into the element.
A record of work carried out will be found on a...?