What is the final step when configuring policy-based routing?
Define access lists.
Configure policy with the use of the route-map command.
Apply policy to an interface using ip policy route-map command.
Apply match commands.
Which prefix-list entry will be used when multiple entries in a prefix list match a given prefix?
all matching entries
entry with the lowest sequence number
entry with the largest sequence number
entry with the longest prefix mask length
Which method of redistribution is least likely to introduce a routing loop into a network?
Which command would allow advertising only an aggregate address of 192.168.0.0/16 when applied by using a neighbor statement that contains prefix-list [prefix-list name] out?
permit 192.168.0.0/0 le 16
permit 192.168.0.0/16 ge 16
permit 192.168.0.0/16 eq 16
Which is the default seed metric for an OSPF route that is redistributed into an EIGRP autonomous system?
Which command would deploy a prefix list in a BGP environment?
ip prefix-list distribute
ip bgp prefix-list distribute
neighbor [ip address] prefix-list prefix-list-name [in/out]
neighbor [ip address] prefix-list-name [in/out]
A router has learned the route 192.168.254.0 /24 from multiple sources.
These sources are as follows:
- RIPv1 route with a metric of 12
- EIGRP with a metric of 125689
- OSPF E2 route with a metric of 125
- EIGRP external route with a metric of 3489
- OSPF type 1 route with a metric of 632
- OSPF route with a metric of 4
What route will be injected into the routing table?
D with metric of 125689
E1 with a metric of 632
E2 with a metric of 125
EX with a metric of 3489
O with a metric of 4
R with metric of 12
Which criterion must be met before a route can be redistributed into another routing protocol?
be directly connected
be learned through a dynamic routing protocol
exist in the routing table
be learned from a different routing protocol than the protocol into which it is redistributed
have an administrative distance that is greater than that of the routing protocol into which it is being
Which statement best describes the route tag in a RIPv2 packet?
The route tag contains a 32-bit mask that identifies the network and subnet portion of the IP address.
It contains the IP address of the next hop that is listed in the IP Address field.
It differentiates between a request for a full routing table or a partial routing update due to a topology
It indicates how many internetwork hops or routers have been traversed in the trip to the destination.
It differentiates between routes that are learned within the autonomous system and those that were redistributed into the routing process.