Cutter Comp Cancel

Rapid Traverse Motion

Spindle Stop

Linear Interpolation Motion

Circular Interpolation Motion,
Clockwise

Tool Change

Absolute Programming Positioning

Circular Interpolation Motion,
Counter-Clockwise

Cutter Comp RIGHT of programmed path

Subprogram Call

Tool Length Compensation +

Work Coordinate #1 (Part Zero Offset)

Canned Cycle Cancel

Coolant ON Command

Drill Canned Cycle

Tapping Canned Cycle

Incremental Programming Positioning

Canned Cycle Rapid Plane Return

The _____ code is used for a Program Stop command on the machine. It stops the spindle, turns off coolant and stops look-ahead processing. Pressing CYCLE START again will continue the program on the next block of the program.

Spindle Start Clockwise

Spindle Start Counter-Clockwise

Coolant OFF Command

Program End and Reset to beginning of program

Local Subroutine Call

Subprogram Return (M98) or Subroutine Return (M97), or a Program loop

Cutter Compensation LEFT of the programmed path

Machine Home (Rapid Traverse)

Spot Drill Canned Cycle

The ____ code is used for an Optional Program Stop command. Pressing the OPT STOP key on the control panel signals the machine to perform a stop command when the control reads an ____ command. It will then perform like an M00.

Peck Drill Canned Cycle

Machine Coordinate Positioning, Non-Modal

Canned Cycle Initial Point Return