GoConqr hat ein neues Design! Sag uns, wie es dir gefällt.

Kostenlos registrieren

Quiz

TEST 1

Esteban Utreras 10 Fragen

Quiz starten

Fragen in diesem Quiz (10)

  1. 1How does BGP prevent routing loops?
    1. AIf the router receives a BGP advertisement that contains its AS number, that route is ignored.
    2. BBGP creates a link-state tree similar to OSPF.
    3. CThrough the use of hold-down timers.
    4. DIf the router receives a BGP advertisement that contains its own Router ID, that route is ignored.
  2. 2Which rule states that a BGP router should not advertise to external neighbors, destinations learned from inside BGP neighbors unless those destinations are also known via an IGP?
    1. ABGP Synchronization
    2. BBGP Split Horizon
    3. CBGP Harmonization
    4. DIGP Split Horizon
  3. 3The EIGRP metric weights command sets how many different variables?
    1. A5
    2. B4
    3. C7
    4. D6
  4. 4By default, what does EIGRP include in its metric calculation? (Select 2 answers).
    1. AMinimum bandwidth (slowest bandwidth)
    2. BCumulative delay
    3. CCumulative bandwidth
    4. DMaximum bandwidth (fastest bandwidth)
    5. EMinimum delay (smallest delay)
    6. FMaximum delay (largest delay)
  5. 5Which show command has the same function or produces the same kinds of information show ip___ or show ipv6 ___?
    1. Aroute
    2. Broute eigrp topology
    3. Cprotocols
    4. Deigrp route detail
  6. 6Routers R1, R2, and R3 have been configured with the commands router eigrp 1 and network 10.1.0.0 0.0.255.255. Which commands would display the known neighbors via EIGRP?
    1. Ashow ip route
    2. Bshow ip eigrp neighbors
    3. Cshow interfaces eigrp
    4. Dshow ip eigrp interfaces
  7. 7What is the result of the following commands?

    R1(config)# ip prefix-list filter-area-51 seq 5 deny 192.168.1.0/24
    R1(config)# ip prefix-list filter-area-51 seq 10 permit 0.0.0.0/0 le 32
    R1(config)# router ospf 1
    R1(config-router)# area 51 filter-list prefix filter-area-51 in
    1. AR1 will filter the 192.168.1.0/24 Type 3 LSA, denying it to be sent into and out of area 51. All other LSAs into and out of area 51 will be permitted.
    2. BR1 will filter the 192.168.1.0/24 Type 3 LSA from area 51, denying it to be sent into all other areas. All other Type 3 LSAs from area 51 will be permitted.
    3. CR1 will filter the 192.168.1.0/24 LSA Type 3, denying it to be sent into area 51. All other Type 3 LSAs into area 51 will be permitted.
    4. DR1 will filter the 192.168.1.0/24 LSA Type 3 from area 51, denying it to be sent into all other areas. All other Type 3 LSAs from area 51 will be permitted.
  8. 8Which of the following statements represents a default behavior for redistribution into OSPF? (Select 2 answers)
    1. AUses a default metric of 1, when learning routes from BGP.
    2. BWhen taking from all other sources, use a default metric of 30.
    3. CRedistribute routes of classful networks, and any associated subnets.
    4. DUses a default metric of 20, when learning routes from all other routing sources (except BGP).
  9. 9Refer to the diagram. R1 and R2 are eBGP peers. R2, R3, and R4 are full mesh iBGP peers and are not running an IGP. The only routes in R4’s routing table are those within AS 200. R4 does not have the 10.0.0.0/8 network in its routing table, even though the route does appear in its BGP table. What is most likely the problem?Bild zu Frage 9
    1. AR4 does not install the 10.0.0.0/8 network in its routing table because R1 needs to use the eBGP multi-hop option to reach R4.
    2. BR4 does not install the 10.0.0.0/8 network in its routing table because the no synchronization command has not been configured on all of the routers in AS 200.
    3. CR4 does not install the 10.0.0.0/8 network in its routing table because it does not have a route to the next-hop address, 172.30.1.1.
  10. 10Which of the following are components of Cisco Express Forwarding (CEF)? (Select 2 answers)
    1. AForwarding Information Base (FIB)
    2. BAdjacency table
    3. CRouting Information Base (RIB)
    4. DARP cache

Informationen

Beschreibung
Quiz am TEST 1, erstellt von Esteban Utreras am 20/06/2016.
Sprache
Español
Aufrufe
0
Bewertung
Noch keine Bewertungen
Bewerte dieses Quiz
Bewerte dieses Quiz

Feedback

Worum geht es?

Wie gefällt dir das neue Design?

Dein Eindruck