Karteikarten
CPL - Systems
Karten in diesem Stapel (15)
- 1What is the function of the Right Squat Switch?Stall Warning Heating
Engine Pre-Glow
ECU Test
TAS Voice Warning (if installed) - 2What is the function of the Left Squat Switch?On ground landing gear
- 3Why do we add x 1.43 to the LDR?EASA CAT.POL.A.330
Landing - Dry Runways specifies to allow a full stop landing from 50 ft screen height above THR within 70% = (x 1.43) of the LDA
- taking into account: (1) ALT at AD;
(2) max 50% HWC and min 150% TWC;
(3) RWY SFC Type & Condition;
(4) RWY Slope - 4What is the function of the winglets?Reduce Tip Vortices and Induced Drag
- 5What is the total amount of Usable Fuel?50 US Gallons Usable
1 US Gallon Unusable each side - 6How does the airconditioning work? (Recirculating Air - Cabin Cooling System)...
- 7Why does the DA 42 has a Variable Elevator Stop?...
- 8Describe the operation and system limits of the Variable Elevator Stop system?...
- 9What is the Certification Basis for the DA42 NG-VI?JAR-23, published on 11-Mar-1994, including Amdt. 1, and additional requirements as laid down in CRI A-01.
- 10What is the Wingspan (incl. ACL)?13.55 m
44.5 ft - 11What's the buzzing noise when you start the Electrical Master Switch?The electrically driven hydraulic gear pump activates itself for 5 to 20 seconds in order to restore the system pressure. Should the pump continue to operate continuously or periodically, terminate flight preparation, there is a malfunction in the landing gear system.
- 12What are the components of the Recirculating Air Cabin Cooling System?- AUX POWER (switch and control panel)
- Central Unit (aft of baggage compartment)
-Additional alternator (LH engine) - 13How is electrical power provided for the Recirculating Air Cabin Cooling System?The RACCS is not connected to the electrical system of the airplane. An additional Alternator (#3) on the LH engine provides electrical power via a V-belt connected to a drive disc at the propeller shaft.
- 14How does the central unit of the Recirculating Air Cabin Cooling System work?The control box operates the electrically driven compressor and all essential control elements (heat exchangers, air in/outlets) of the central unit in order to achieve the preset temperature.
- 15What is considered as Icing Conditions?- Visually detected ice
- Presence of visible moisture in any form at an OAT of +3°C or below
Informationen
- Beschreibung
- CPL Karteikarten am CPL - Systems, erstellt von Stanislaz Yanishlaz am 04/12/2017.
- Erstellt von
- Stanislaz Yanishlaz
- Aufrufe
- 0
- Bewertung