12 month (2)

1

"The chemical decomposition of a compound into one or more other substances by heat alone" is called ________________.

1

A flammable liquid has which of the following characteristics?

1

A liquid with a specific gravity of 1.4 ___________________

1

All matter that exist in a gaseous state will burn.

1

All of the following are examples of mechanical heat sources except _____________.

1

All of the following are measurements of heat energy except __________.

1

All of the following are warning signs of backdraft except ______________.

1

All of the following are warning signs of flashover except _______________.

1

An ignitable liquid must be atomized in order to burn.

1

Conditions that will cause a static electricity discharge include the following except ___________.

1

Factors that affect he rate in which a fire will grow include all of the following except ___________.

1

Firefighters need to have a working knowledge of combustion dynamics, chemistry, physics, and basic engineering principles in order to attack and control fire.

1

Flashover can be defined as occurring when a fire changes from being a fuel-controlled fire to a ventilation-controlled fire.

1

In most cases, a fuel must be in a ______________ state to burn.

1

Match the item with the term below: Fire is affected by the amount of oxygen, fuel, space and insulation of ceilings and walls.

1

Match the item with the term below: Fire is virtually free burning and has plenty of oxygen.

1

Match the item with the term below: Fuel package has been mostly consumed and heat release rate drops.

1

Match the item with the term below: Heat generated from the ignition now begins to cause heart transfer to surrounding combustibles.

1

Match the item with the term below: In most cases, the fire is small and limited.

1

Match the item with the term below: Small pockets of fire may still exist as the fuel slowly moves the point of total consumption.

1

Matter can change from ________________ by heating or cooling, by applying pressure, or by releasing pressure.

1

Mechanical heat sources include friction and compression.

1

Oil-soaked rags, discarded and reaching self-ignition temperature are examples of a(n)__________.

1

One of the dangers associated with rollover is that fire can travel overhead and behind the firefighters and block their egress from the structure.

1

Regular firefighting gear provides a small degree of protection to the firefighter from radiation.

1

Specific gravity and vapor density measure the same basic principle and can be used interchangeably.

1

The amount of heat generated by electrical means depends on several variables including_____________.

1

The amount of heat that a substance absorbs as the temperature of the substance increases is called___________.

1

The danger of backdraft increases dramatically as oxygen levels drop below_________.

1

The latent heat of vaporization is___________________.

1

The process of changing a solid directly to a gas is called__________.

1

There are two types of explosions: conflagration and detonation.

1

Two forms of nuclear energy are:

1

Vapor density is the comparison of the density of a given vapor or gas to the density of__________.

1

Which choice is not part of the fire tetrahedron?

1

Which of the following is not one of the four stages of fire development?

1

Which of the following is true regarding lower explosive limits (LEL)?

1

Which of the following solids would be the easiest to ignite?

1

Which statement about density is true?

1

According to Boise Fire SOP 206.10, High Rise Operations (Initial Response) which engine will have the responsibility of establishing water supply?

1

According to Boise SOP 206.10, High Rise Operations (Initial Response) which of the following equipment is NOT listed as part of the minimum to be brought in by the first arriving engine?

1

According to Boise SOP 206.12 High Rise Operations (Elevator Use), once determined safe, what is the highest floor the elevator may be used to transport personnel and equipment prior to fire control?

1

According to Boise SOP 206.12, High Rise Operations (Elevator Use), never overload an elevator as
a general rule _____ firefighters plus equipment shall constitute a full load.

1

According to SOP 206.10, what group of resources constitutes the "Fire Attack Group" during a high rise operation?

1

According to training guide "High Rise", the basic fire attack approach is a ft stretch from ____.

1

According to training guide, "High Rise", who would be a good choice for "Standpipe control"?

1

Each BFD company carries a 2 1/2" smooth bore nozzle with an 1 1/8" solid stream tip for high rise operations. Approximately how many gpm does this tip provide when supplied at 50psi?

1

What piece of equipment is required when stacking a charged 2 1/2" line?

1

What size of hose should be used initially in fighting a high rise fire?

1

When preparing to make entry on the fire floor, the Nozzleman should open his nozzle until _____________________.

1

Which of the following is NOT a type of pressure regulating device?

1

According to the NFPA Standard on Life Safety Rope and Equipment for Emergency Services, which of
the following would cause a life safety rope to be removed from service?

1

Prior to the adoption of the NFPA Standard on Life Safety Rope and Equipment for Emergency Services, which was a common practice regarding rope use in the fire service?

1

What is the safety factor of a life safety rope.

1

Which is the NFPA Standard on Life Safety Rope and Equipment for Emergency Services?

1

After a life safety rope has been “downgraded,” it is most usually used as a ________.

1

All equipment hoisted by utility ropes should have _____________________.

1

If the manufacturer’s instructions cannot be found, synthetic rope may be washed using cold water
and a mild detergent in a diluted solution.

1

Match the item with the correct choice below: Becket bend

1

Match the item with the correct choice below: Bight

1

Match the item with the correct
choice below: Clove hitch—closed

1

Match the item with the correct
choice below: Clove hitch—open

1

Match the item with the correct choice below: Loop

1

Match the item with the correct choice below: Overhand (safety knot)

1

Match the item with the correct choice below: Round turn

1

Match the item with the correct choice below: Running end

1

Match the item with the correct choice below: Standing end

1

Match the item with the correct choice below: Working end

1

Natural fiber ropes are especially resistant to abrasion.

1

Natural fiber ropes need to be bigger in order to be stronger.

1

Polyester rope has a relatively low stretch under a load, but does not hold up well if a shock load is applied.

1

Rope made from Manila, sisal, or cotton is termed ____________________________.

1

Ropes should be inspected after every use. It is recommended that ropes have a usage and inspection
card.

1

Static (low stretch) rope is used in most fire department applications.

1

Synthetic material ropes are stronger than natural fiber ropes because each continuous fiber is the same length.

1

Which of the following is not a recommended method for drying a rope?

1

Channel announcement will be preempted by radio traffic?

1

Dispatch can tell that it’s your radio that is transmitting anytime you key the mic.

1

Does channel announcement work in all zones and on all channels?

1

For the clearest communication the microphone should be held 1 to 2 inches from your mouth (no SCBA mask).

1

How can I reset my radio after an accidental activation of the EMER button?

1

How long do you need to press the EMER button to send an emer alert to Dispatch?

1

How long does will your radio transmit when EMER is activated?

1

How many channels are there in each zone?

1

I quickly press the select button on the face of the radio and the radio does not respond. Why not?

1

In Zone C all of the channels are on the 700MHz trunked system except:

1

It doesn’t matter which portable radio I use that is assigned to my apparatus.

1

Scenario: A firefighter loses consciousness, falls down, and inadvertently keys his mic, essentially tying up the talk group he was operating on. How long will that firefighter’s radio tie up the channel with its open mic?

1

The term simplex means that a radio transmission goes from one radio to another.

1

What clues tell you that you are on a channel that is on the 700MHz trunked system?

1

What does 1A stand for?

1

What does Dispatch need to hear from you if you have had an accidental activation of the EMER button?

1

What does the home button do?

1

What zone do we primarily operate in on a day to day basis?

1

What zone does Boise Police primarily operate in on a day to day basis?

1

When the APX7000 is turned off and then back on, what zone and channel will it default to?

1

When wearing an SCBA mask, the clearest communication will be by placing the microphone 1 to 2 inches in front of the SCBA regulator.

1

Which of the following is NOT a feature available on a 700MHz trunked channel?

1

Which of the following will the keypad lock NOT disable?

1

Which term correctly refers to the radio mounted in your apparatus?

1

12 moth study guide continued

12 month (2)

12 month (2)

"The chemical decomposition of a compound into one or more other substances by heat alone" is called ________________.

A flammable liquid has which of the following characteristics?

A liquid with a specific gravity of 1.4 ___________________

All matter that exist in a gaseous state will burn.

All of the following are examples of mechanical heat sources except _____________.

All of the following are measurements of heat energy except __________.

All of the following are warning signs of backdraft except ______________.

All of the following are warning signs of flashover except _______________.

An ignitable liquid must be atomized in order to burn.

Conditions that will cause a static electricity discharge include the following except ___________.

Factors that affect he rate in which a fire will grow include all of the following except ___________.

Firefighters need to have a working knowledge of combustion dynamics, chemistry, physics, and basic engineering principles in order to attack and control fire.

Flashover can be defined as occurring when a fire changes from being a fuel-controlled fire to a ventilation-controlled fire.

In most cases, a fuel must be in a ______________ state to burn.

Match the item with the term below: Fire is affected by the amount of oxygen, fuel, space and insulation of ceilings and walls.

Match the item with the term below: Fire is virtually free burning and has plenty of oxygen.

Match the item with the term below: Fuel package has been mostly consumed and heat release rate drops.

Match the item with the term below: Heat generated from the ignition now begins to cause heart transfer to surrounding combustibles.

Match the item with the term below: In most cases, the fire is small and limited.