GoConqr hat ein neues Design! Sag uns, wie es dir gefällt.

Quiz

wirelessQ1

michael.0lsn 27 Fragen

Quiz starten

Fragen in diesem Quiz (27)

  1. 1How many antennas are used with diversity?
    1. AFOUR
    2. BONE
    3. CTHREE
    4. DTWO
  2. 2Which of the following measurements is referenced against an antenna that radiates perfectly in all directions?
    1. AdBi
    2. BdBm
    3. CdBd
    4. DdB
  3. 3Bob works as a network administrator for ABC Auto Inc. The company deploys a wireless LAN network but there is some problem due to the interference of signals. Which of the following tools should you use to determine signal strength, noise level. (Choose two.)
    1. ASNR
    2. BdBm
    3. CRSSI
    4. DEIRP
  4. 4A single 802.11 access point has been configured and installed in the center of a square office. A few wireless users are experiencing slow performance and drops while most users are operating at peak efficiency. What are three likely causes of this problem? (Choose three)
    1. ANull SSID
    2. BMetal file cabinets
    3. CCordless phones
    4. DAntenna type or direction
    5. EMismatched SSID
  5. 5To display the coverage from the top of the antenna, what plane is represented?
    1. AAirplane
    2. BC-Plane
    3. CE-Plane
    4. DH-Plane
  6. 6Metal desks, glass, light fixtures, and computer screens can contribute to which influence on wireless transmissions?
    1. AAbsorption
    2. BScattering
    3. CReflection
    4. DRefraction
  7. 7Which of the following statements is true about free space path loss?
    1. ARF signals will attenuate as they travel because of obstructions
    2. BPath loss occurs at a constant linear rate
    3. CPath loss primarily occurs because of cancellation
    4. DRF signals will attenuate as they travel despite the lack of attenuation caused by obstructions.
  8. 8What does amplitude measure?
    1. ADistance from high crest to high crest horizontally in a waveform
    2. BDistance between two access points
    3. CHeight of wave from lowest crest to highest crest
    4. DDistance from low crest to midspan in a waveform
  9. 9Using knowledge of RF characteristics and behaviors, which two options should a WLAN engineer be most concerned about during an indoor site survey? (Choose two.)
    1. AUser Density
    2. BBrick Wall
    3. CIndoor temperature
    4. DDry wall
  10. 10Bob works as a network administrator for the superawesomedelvery.com at Calgary. Bob was asked to implement WLAN in an office area. He deployed APs with internal antennas and mounted them on the wall. After Bob deployed APs, neighboring companies; specially, ones are a floor above and below have been complaining about interferences. What is likely caused the interferences?
    1. AIncorrect type of APs are used
    2. BIncorrect installation- APs should be mounted on the celling
    3. CIncorrect antennas used –should have used external antennas
    4. DIncorrrect type of cables and connectors are used

Informationen

Beschreibung
notes.
Sprache
English
Aufrufe
236
Bewertung
Noch keine Bewertungen
Bewerte dieses Quiz
Bewerte dieses Quiz

Feedback

Worum geht es?

Wie gefällt dir das neue Design?

Dein Eindruck