Quiz
26208-14 Conductor Termination and Splices - Quiz (1)
Fragen in diesem Quiz (6)
1To properly install heat-shrink insulators, _____.
- Aapply heat for a few seconds and then install the insulator
- Buse PVC cement on the insulator before applying any heat
- Cslip the insulator over the connector and apply heat for a few seconds
- Dtape the insulator in place before applying heat
2Which of the following inscriptions on a wire connector indicates that it is designed for use on both copper and
aluminum wire?- ACSA
- BUL
- CAL-AL
- DAL-CU
3A true statement concerning solid versus stranded conductors is _____.
- Athe same size stripping tool may be used for both
- Bthe wire diameters are the same in both types
- Cthere is no difference in the two types
- Dthe diameters are different
4Before a splice or connection can be made to a Type THHN conductor, the _____.
- Aconductor ends must be stripped and cleaned
- Blength must be measured
- Cthickness of the insulation must be measured
- Dends should be wrapped with THHN tape
515. Which of the following eliminates the need for taping and the use of filler tape?
- AHeat-shrink insulator
- BParallel-tap connector
- CMotor connection kit
- DWire nut
6The NEC® section that governs electrical connections and splices is _____.
- ANEC Article 725
- BNEC Section 110.14
- CNEC Table 312.4
- DNEC Section 240.21
Informationen
- Beschreibung
- General Electrician Quiz am 26208-14 Conductor Termination and Splices - Quiz (1), erstellt von hcannaday am 20/05/2016.
- Autor
- hcannaday
- Sprache
- English
- Aufrufe
- 36
- Schlagwörter
- Bewertung
- Noch keine Bewertungen Bewerte dieses Quiz