¡GoConqr estrena diseño! Cuéntanos qué te parece.

Regístrate gratis

Test

Routing II

Marcos Avila 9 preguntas 5,0 (1 valoración)

Hacer el test

Este test tiene tipos de pregunta que se abren en el reproductor de siempre.

Preguntas del test (9)

  1. 1[blank_start]Source IP (default)[blank_end] Sessions from the same source IP address use the same route.

    [blank_start]Source—destination IP[blank_end] Sessions with the same source and destination IP use the same route.

    [blank_start]Weighted[blank_end] Sessions are distributed based on route, or interface weights.

    [blank_start]Usage (spillover)[blank_end] One route is used until the volume threshold is reached, then the next route is used.
    1. ASource IP (default)
    2. BSource—destination IP
    3. CWeighted
    4. DUsage (spillover)
  2. 2Defaul ECMP method on Fortigate
    1. ASource IP
    2. BWeighted
  3. 3How does FortiGate load balance traffic when using the spillover method in ECMP routing? .
    1. Aa. Sessions are distributed based on interface threshold.
    2. Bb. Sessions are distributed based on route weight.
  4. 4RPF
    1. AReverse Path Forwarding
    2. BReverse Port Forwarding
  5. 5RPF Method
    1. ALoose
      Strict
    2. BLoop
      Strict
  6. 6[blank_start]strict—src—check disable[blank_end] — Loose RPF (default)
    Checks only for the existence of at least one active route back to the source using the incoming interface.

    [blank_start]strict—src—check enable[blank_end] — Strict RPF
    Checks that the best route back to the source uses the incoming interface.
    1. Astrict—src—check disable
    2. Bstrict—src—check enable
  7. 7Default RPF check method on Fortigate
    1. ALoose
    2. BStrict
  8. 8Which of the following route lookup scenarios Will satisfy the RPF check for a packet?
    1. Aa. Routing table has an active route for the destination IP of the packet. .
    2. Bb. Routing table has an active route for the source IP of the packet.
  9. 9When using link health monitoring, which route attribute must also be configured to achieve route failover protection?
    1. Aa. Distance
    2. Bb. Metric

Información

Descripción
NSE4 6.0 NSE4 6.0 Test sobre Routing II, creado por Marcos Avila el 05/07/2018.
Idioma
Español
Visitas
180
Etiquetas
nse4 6.0
Valoración
5,0 de 5 · 1 valoración
Valora este test
Valora este test

Escríbenos

¿Sobre qué es tu mensaje?

¿Qué te parece el nuevo diseño?

¿Te gusta?