Software-Defined WAN I

SD-Wan configuracion setting needed:

[blank_start]Source IP[blank_end]: Traffic from the same IP address uses the same link. [blank_start]Source-destination IP[blank_end]: Traffic from the same pair of source and destination IP addresses uses the same link. [blank_start]Spillover[blank_end]: This method is similar to the spillover method used by ECMP. A link routes all the traffic until the volume reaches a threshold, after that, another link is used. [blank_start]Sessions[blank_end]: The interface weights determine the proportion of sessions that each link should handle. Sessions are distributed among the links, based on the interface weights. [blank_start]Volume[blank_end]: The interface weights determine the proportion of traffic volume that each link should handle. Sessions are balanced so that traffic volume is distributed based on the interface weights.

Which method of load balancing is supported by SD-WAN but not supported by ECMP routing?

Which of the following configuration tasks is correct when implementing SD—WAN?

SD-WAN Status check configuration available only via CLI: (select 3)

Which one of the following link attributes is used in SD- WAN link quality measurements?

Which of the following status check protocols is only available from the CLI? .

Which of the following is an SD—WAN rule matching parameter for traffic sources?

You can configure SD—WAN rules to choose the egress interface based on which one of the following parameters? .

Which of the following should be used to monitor the session distribution across the SD—WAN member interfaces?

When verifying SD—WAN traffic routing with the CLI packet capture tool, which verbosity level should you use?