¡GoConqr estrena diseño! Cuéntanos qué te parece.

Fichas

Measuring Current, Voltage, and Resistance (Mod.2 Sect.2 Part4)

That Yeti Dog Person Electronics Technician Career Diploma Inglés 17 fichas

Fichas del conjunto (17)

  1. 1_____ are tools that you can use to measure circuit quantities.Meters
  2. 2There are two basic types of meters used today: the _____ meter and the _____ meter.analog, digital
  3. 3An ____ meter contains a moving pointer and a calibrated scale.analog
  4. 4In an analog meter, the current that causes the pointer to move all the way to the right end of the scale is called _______.full-scale current
  5. 5Two types of analog meter are used in measuring current: the _____ and the _________.ammeter, volt-ohm-milliammeter (VOM)
  6. 6The abbreviation for "volt-ohm-milliammeter" is ____.VOM
  7. 7A ____ has multiple scales for measuring current, and can generally measure current in a range from microamperes up to about 10 A.VOM
  8. 8Digital meters are usually called ______.digital multimeters (DMM)
  9. 9The abbreviation for "digital multimeter" is ____.DMM
  10. 10A ______ gives readouts of current values on a four-digit display. This type of display gives more exact measurements than analog meters.digital multimeter
  11. 11A _____ is used to measure voltage.voltmeter
  12. 12High-voltage circuits should never be measured without the use of an accessory probe called a _______.high-voltage probe
  13. 13______ is a feature on a digital meter where the range is automatically set inside the meter.Autoranging
  14. 14______ is a feature on a digital meter where the meter displays the polarity of the voltage.Autopolarity
  15. 15An _____ contains an internal battery, a milliammeter, and a scaling resistor.ohmmeter
  16. 16Always observe two cautions when taking resistance measurements: First, be sure to remove all circuit power. Second, ________________ to the component. Parallel paths will greatly lower the ohmmeter's readings.remove any parallel circuit paths
  17. 17A _______ is the checking of a circuit to see if current flows (that it is in fact a complete circuit).continuity test

Información

Descripción
This was actually a bit interesting.
Visitas
47
Valoración

Escríbenos

¿Sobre qué es tu mensaje?

¿Qué te parece el nuevo diseño?

¿Te gusta?