Fichas
G & M Codes (Haas, Basic)
Fichas del conjunto (32)
- 1Cutter Comp CancelG40
- 2Rapid Traverse MotionG00
- 3Spindle StopM05
- 4Linear Interpolation MotionG01
- 5Circular Interpolation Motion, ClockwiseG02
- 6Tool ChangeM06
- 7Absolute Programming PositioningG90
- 8Circular Interpolation Motion, Counter-ClockwiseG03
- 9Cutter Comp RIGHT of programmed pathG42
- 10Subprogram CallM98
- 11Tool Length Compensation +G43
- 12Work Coordinate #1 (Part Zero Offset)G54
- 13Canned Cycle CancelG80
- 14Coolant ON CommandM08
- 15Drill Canned CycleG81
- 16Tapping Canned CycleG84
- 17Incremental Programming PositioningG91
- 18Canned Cycle Rapid Plane ReturnG99
- 19The _____ code is used for a Program Stop command on the machine. It stops the spindle, turns off coolant and stops look-ahead processing. Pressing CYCLE START again will continue the program on the next block of the program.M00
- 20Spindle Start ClockwiseM03
- 21Spindle Start Counter-ClockwiseM04
- 22Coolant OFF CommandM09
- 23Program End and Reset to beginning of programM30
- 24Local Subroutine CallM97
- 25Subprogram Return (M98) or Subroutine Return (M97), or a Program loopM99
- 26Cutter Compensation LEFT of the programmed pathG41
- 27Machine Home (Rapid Traverse)G28
- 28Spot Drill Canned CycleG82
- 29The ____ code is used for an Optional Program Stop command. Pressing the OPT STOP key on the control panel signals the machine to perform a stop command when the control reads an ____ command. It will then perform like an M00.M01
- 30Peck Drill Canned CycleG83
- 31Machine Coordinate Positioning, Non-ModalG53
- 32Canned Cycle Initial Point ReturnG98
Información
- Descripción
- These are the codes that an interviewer will ask you about if you're looking for a job as a CNC Machine Operator. You could absolutely nail the interview but your knowledge of these codes will decide in the end if an employer thinks your fit for the job. I made these flashcards to help myself study and learn but anyone can feel free to use them if needed.
- Creado por
- Joey Higgins
- Visitas
- 25
- Etiquetas
- Valoración