Fichas
Faults in Woods
Fichas del conjunto (4)
- 1CuppingWhen timber bends across the grain.
Annual rings can be clearly seen on the end of the wood and the varying length of them means the wood dries at different speeds. This means the wood shrinks at different rates and cups. - 2TwistingCan twist as it dries if the wood has come from the centre of a tree and has a spiral grain.
Normally unusable. - 3SplittingWhere the grain separates at the end of a piece of wood - only thing to do is cut the affected ends off.
- 4KnotsNatural by-product of where branches were attached to the tree.
Can become loose and drop out if dead - which is very dangerous if the wood is being machined.
Can be tight however, and even then are still a nuisance in terms of working the wood.
Softwoods like pine tend to have many more knots.
Información
- Descripción
- A-Levels (Industrial and Commercial Practice) Resistant Materials Fichas sobre Faults in Woods, creado por Alec Stevens el 10/05/2013.
- Creado por
- Alec Stevens
- Visitas
- 73
- Etiquetas
- Valoración