¡GoConqr estrena diseño! Cuéntanos qué te parece.

Regístrate gratis

Test

Software-Defined WAN I

Usuario eliminado 11 preguntas Actualizado el 11 abr 2019

Hacer el test

Este test tiene tipos de pregunta que se abren en el reproductor de siempre.

Preguntas del test (11)

  1. 1SD-Wan configuracion setting needed:
    1. AMember interfaces
      Load balancing method
    2. BGroup member interfaces
      Load balancing algorithm
  2. 2[blank_start]Source IP[blank_end]: Traffic from the same IP address uses the same link.

    [blank_start]Source-destination IP[blank_end]: Traffic from the same pair of source and destination IP addresses uses the same link.

    [blank_start]Spillover[blank_end]: This method is similar to the spillover method used by ECMP. A link routes all the traffic until the volume reaches a threshold, after that, another link is used.

    [blank_start]Sessions[blank_end]: The interface weights determine the proportion of sessions that each link should handle. Sessions are distributed among the links, based on the interface weights.

    [blank_start]Volume[blank_end]: The interface weights determine the proportion of traffic volume that each link should handle. Sessions are balanced so that traffic volume is distributed based on the interface weights.
    1. ASource IP
    2. BSource-destination IP
    3. CSpillover
    4. DSessions
    5. EVolume
  3. 3Which method of load balancing is supported by SD-WAN but not supported by ECMP routing?
    1. AVolume
    2. BSessions
  4. 4Which of the following configuration tasks is correct when implementing SD—WAN?
    1. Aa. Configure a default route using the sd—wan virtual interface.
    2. Bb. Configure firewall policies for each individual member interfaces.
  5. 5SD-WAN Status check configuration available only via CLI: (select 3)
    1. Atcp-echo
    2. Budp-echo
    3. Ctwamp
    4. Dping
    5. Essl
    6. Fwarning jitter
    7. Gjitter
  6. 6Which one of the following link attributes is used in SD- WAN link quality measurements?
    1. Aa. Cost
    2. Bb. Latency
  7. 7Which of the following status check protocols is only available from the CLI? .
    1. Aa. TCP—Echo
    2. Bb. HTTP
  8. 8Which of the following is an SD—WAN rule matching parameter for traffic sources?
    1. Aa. User groups
    2. Bb. IPS signatures
  9. 9You can configure SD—WAN rules to choose the egress interface based on which one of the following parameters? .
    1. Aa. Cost
    2. Bb. Latency
  10. 10Which of the following should be used to monitor the session distribution across the SD—WAN member interfaces?
    1. Aa. SD—WAN Link Status monitor
    2. Bb. SD—WAN Usage monitor

Información

Descripción
El usuario ha eliminado su información de asignaturas Test sobre Software-Defined WAN I, creado por Usuario eliminado el 20/09/2018.
Autor
Usuario eliminado
Idioma
English
Visitas
39
Historial
Creado el 20 sep 2018 · actualizado el 11 abr 2019

Escríbenos

¿Sobre qué es tu mensaje?

¿Qué te parece el nuevo diseño?

¿Te gusta?