Ajude a dar forma ao GoConqr. O que a gente deve adicionar?

Mapa mental

DHCPv4

NICOLAS TORRES Espanhol

Mind map about DHCPv4: what it is, message format, server configuration and SLAAC

Mind map: DHCPv4

Conteúdo do mapa

DHCPv4

  1. What is it?

    • It is a network protocol of client / server type which assigns directions dynamically
      • Steps to make a lease
        • 1. DHCPDISCOVER: The client sends a broadcast message to all DHCPv4 servers available
        • 2. DHCPOFFER: When it detects the DHCPDISCOVER message reserve an IPv4 address for the client
        • 3. DHCPREQUEST: With this message the client accepts the link to the server
        • 4. DHCPACK: Message from server acceptance
  2. DHCPv4 message format

    • Operation code (OP)
      • specifies the general message type
    • Type of hardware
      • identifies the type of hardware that is used In the net
    • Address length of hardware
      • specify the length of the address.
    • Jumps
      • controls the forwarding of messages
    • Transaction identifier
      • Use to match the information with the response received
    • Seconds
      • identifies the number of seconds elapsed trying to connect the client with the server
    • Indicators
      • they are used by a client who does not know their IPv4 address when you send a request
    • Client's IP address
      • a uses a client during the lease renewal
    • Your IP address
      • to use the server to assign an IPv4 address to the client
    • IP address of the server
      • Identify the server address that the client should use
    • IP address of the gateway
      • Routes DHCPv4 messages when relay agents intervene
    • Direction of hardware client
      • specifies the physical layer of the client.
    • Boot file name
      • is used by a client to request a certain type of boot file
    • DHCP options
      • contains the DHCP options
  3. Configuration of a server Basic DHCPv4

    • Step 1: Exclude IPv4 addresses
      • use the ip dhcp excluded-address command
        • To exclude specific addresses
    • Step 2: Configure a DHCPv4 pool
      • the ip command dhcp pool set-name
        • create a set with the given name and place the router in DHCPv4 configuration mode
    • Step 3: Configure specific tasks
      • Use the network command
        • to define the range of available addresses
      • Use the default-router command
        • to define the default gateway router
    • Disabling DHCPv4
      • use the no service dhcp command
  4. Verification of DHCPv4

    • comando show running-config | section dhcp
      • show the DHCPv4 commands configured
    • show ip dhcp binding command
      • You can verify the operation of DHCPv4
    • show ip dhcp server statistics
      • Verify if the router receives or sends messages
  5. Relay of DHCPv4

    • What is the DHCP relay?
      • Runs when a router forwards requests of assignment / address parameters
  6. Automatic address configuration State-independent (SLAAC)

    • What is SLAAC?
      • SLAAC is a method in which a device can get a global unicast IPv6 address without the Services of a DHCPv6 server
        • Router request message (RS)
          • The RS message is sent to the multicast IPv6 address when a client is configured to obtain information
        • They serve for the detection of duplicate networks
        • Router announcement message (RA)
          • the routers send RA messages to provide addressing information
            • The RA message includes the prefix and the prefix length of the local segment.
  7. Configuration of a router as a client DHCPv4

    • the ip address dhcp command.
      • To configure an interface Ethernet as a DHCP client
        • the ip address dhcp command
          • the interface is configured
        • the interface * interface * is configured
          • confirms that the interface is activated and that the address was assigned by a DHCPv4 server.

Informações

Descrição
Mapa Mental sobre DHCPv4, criado por NICOLAS TORRES em 31-10-2018.
Criado por
NICOLAS TORRES
Visualizações
2
Avaliação

Mais sobre DHCP and address allocation

Fale Conosco

Sobre o que é sua mensagem?

O que a gente deve adicionar?