Questão 1
Questão
Which one of the following items will require special attention when using a steam
stripper in a domestic environment?
Responda
-
a Television.
-
b Desk.
-
c Kettle.
-
d Radiator.
Questão 2
Questão
Plastic sheeting is sometimes placed under cotton dust sheets when protecting furniture.
Why is this?
Responda
-
a To protect the plastic sheeting.
-
b To prevent dust from transferring through.
-
c To prevent the sheets from slipping off.
-
d To save on the use of cotton sheets.
Questão 3
Questão
Due to its lightness, which one of the following is generally the best sheeting for
covering office equipment?
Responda
-
a Tarpaulin.
-
b Plastic sheet.
-
c Adhesive plastic.
-
d Cotton twill.
Questão 4
Questão
Which one of the following tapes would be the most suitable for masking a previously
painted surface?
Responda
-
a Low tack tape.
-
b Duct tape.
-
c Masking tape.
-
d Insulation tape.
Questão 5
Questão
Which one of the following identifies the best reason for carefully removing masking tape
after the painting has been completed?
Responda
-
a To save time cleaning up.
-
b To allow the paint to flow.
-
c To re-use the masking tape.
-
d To stop paint being lifted off.
Questão 6
Questão
Which one of the following is the most important reason for professionally cleaning dust
sheeting after use?
Questão 7
Questão
Which of the following component parts of a brush is used to bind the setting to the
handle?
Responda
-
a Ferrule.
-
b Stock.
-
c Frame.
-
d Filling
Questão 8
Questão
A short pile Mohair roller is unsuitable for applying emulsion to an embossed surface
because the
Responda
-
a roller would over fill the surface
-
b mohair would come away
-
c roller would skim over the surface
-
d rolling would take too long.
Questão 9
Questão
A water-borne gloss is being applied to a window cill. Why might a synthetic filament
brush be used specifically for this task?
Responda
-
a The filament is easier to clean after use.
-
b The brush marks produce a good texture.
-
c The filament brush is cheaper.
-
d The brush marks are less visible.
Questão 10
Questão
Which one of the following defects may occur if a tin of solvent-borne undercoat paint is
not prepared before use?
Responda
-
a Delayed drying time.
-
b Increased odour.
-
c Blooming.
-
d Cissing.
Questão 11
Questão
Which one of the following surface coatings allows timber to ‘breathe’?
Responda
-
a Gloss paint.
-
b Eggshell paint.
-
c Silk-emulsion paint.
-
d Micro-porous paint.
Questão 12
Questão
Which one of the following paint types would not be stirred prior to use?
Responda
-
a Gloss.
-
b Thixotropic.
-
c Silk-emulsion.
-
d Micro-porous.
Questão 13
Questão
What evaporates when an aluminium primer dries?
Responda
-
a Cellulose thinner.
-
b Methylated spirit.
-
c Distilled water.
-
d White spirit.
Questão 14
Questão
A common problem associated with gloss paint drying in hot and dry conditions is
Responda
-
a rapid drying
-
b loss of gloss
-
c cissing
-
d crazing
Questão 15
Questão
The first component of a panelled door to be painted is the
Responda
-
a stiles
-
b rails
-
c muntins
-
d mouldings.
Questão 16
Questão
If gloss is applied on top of an undercoat of the wrong colour, which defect is likely
to occur?
Responda
-
a Grinning.
-
b Flashing.
-
c Bleeding.
-
d Bleaching.
Questão 17
Questão
Careless application of solvent-borne gloss by roller can cause which of the following
defects?
Responda
-
a Blooming.
-
b Cissing.
-
c Crazing.
-
d Skid marks.
Questão 18
Questão
Strongly coloured painted surfaces exposed to direct sunlight over time may experience
Responda
-
a bleeding
-
b flaking
-
c fading
-
d cissing.
Questão 19
Questão
If a surface is described as ‘friable’, it would appear
Questão 20
Questão
A synthetic filament brush has been used with water-borne gloss paint. Which one of the
following cleaning methods should be used?
Responda
-
a Remove excess paint, wash in sugar soap.
-
b Remove excess paint, wash in methylated spirit.
-
c Remove excess paint, wash in water.
-
d Remove excess paint, wash in solvent.
Questão 21
Questão
How should roller sleeves be stored after cleaning and drying?
Responda
-
a Laid flat in a dry place.
-
b Placed upright in a dry place.
-
c Suspended upright in water.
-
d Laid, submerged in water.
Questão 22
Questão
How should materials with low ‘flash points’ be stored?
Questão 23
Questão
An important reason for stock rotation is to
Responda
-
a prevent stock from degrading
-
b ensure that recent stock is used first
-
c get the best value from bargain prices
-
d minimise the theft of materials.
Questão 24
Questão
Why does paint sometimes ‘skin’ after use?
Responda
-
a Because the solvent evaporates and the surface drys.
-
b Because the oil has leaked from the bottom of the tin.
-
c Due to inappropriate stirring after use.
-
d Due to an incorrect storage temperature.
Questão 25
Questão
When the components of paint separate in the tin, this is known as
Responda
-
a crazing
-
b blooming
-
c cissing
-
d settling.