Ajude a dar forma ao GoConqr. O que a gente deve adicionar?

Flashcards

LLDP

Aliyah Merritt CCNA 2020 CCNA Inglês 18 flashcards

Flashcards do conjunto (18)

  1. 1What is 802.1ab?LLDP
  2. 2What does LLDP stand for?Link Layer Discovery Protocol
  3. 3Does LLDP start automatically?No, LLDP is disabled by default.
  4. 4What is the difference between CDP and LLDP?LLDP is for non-Cisco devices, but they function the same.
  5. 5What are TLVs?Type, Length, and Value descriptions which are attributes supported and used by LLDP.
  6. 6What does MED stand for?Media Endpoint Discovery
  7. 7What does LLDP-MED do?supports the advertisement of network policies for applications like voice or video, device location discovery, abd troubleshooting information.
  8. 8What is an LLDP-MED network policy?An LLDP-MED network policy is a set of configurations for real time applications like voice and video.
  9. 9What does MED do in LLDP-MED?The MED protocol sends traffic as defined by the attached policies.
  10. 10Cisco switches support what discovery protocols?LLDP, LLDP-MED, and CDP.
  11. 11Cisco phones support what discovery protocols?LLDP-MED and CDP.
  12. 12Cisco routers support what discovery protocols?LLDP and CDP.
  13. 13What discovery protocols do third-party phones support?LLDP-MED.
  14. 14What discovery protocols do third-party routers support?LLDP.
  15. 15What are the commands to enable and verify LLDP and LLDP MED?"lldp run"
    "show lldp (interface)"
    "show lldp med config (interface)"
    "show lldp med config (interface) detailed"
  16. 16State the commands to: 1. configure holdtime 2. configure delay time 3. to configure update frequency 4. to transmit LLDP packets only 5. to receive LLDP packets only1. "lldp holdtime (#)"
    2. "lldp reinit (#)"
    3. "lldp timer (#)"
    4. "no lldp receive"
    5. "lldp receive"
  17. 17What are the commands to disable both LLDP and LLDP-MED?"no lldp run"
    "lldp med disable"
    "no lldp med"
  18. 18State the commands to add or remove a policy, change the topology, and determine location for LLDP-MED."lldp med network-policy (add|remove)(#)"
    "lldp med notifications topology-change (enable|disable"
    "lldp med location {(coordinate data)|(ecs-elin data)}

Informações

Descrição
CCNA CCNA 2020 FlashCards sobre LLDP, criado por Aliyah Merritt em 02-06-2020.
Criado por
Aliyah Merritt · jun 2020
Atualizado
2 jun 2020
Visualizações
1
Avaliação

Fale Conosco

Sobre o que é sua mensagem?

O que a gente deve adicionar?