# BSNL TTA ONLINE TEST - 2 Network, Filters and Transmission Lines

### Description

Subject : Network, Filters and Transmission Lines Instruction: Time limit for the exam: 25 Minutes Total number of questions : 30 Q Each question carry 1 mark, no negative marks. DO NOT refresh the page. All the best by BSNL ACADEMY If U Like Our Test series than Share with your friends and Rate Our Tests.
Quiz by BSNL ACADEMY, updated more than 1 year ago More Less
 Created by BSNL ACADEMY about 6 years ago Copied by BSNL ACADEMY about 6 years ago
71
2

## Resource summary

### Question 1

Question
Proximity effect depends on
• frequency
• distance between the conductors
• relative permeability
• all of the above

### Question 2

Question
Skin effective is more in case of
• communication lines
• power lines
• same in both cases
• none of the above

### Question 3

Question
Apart from the skin effect the non uniformity of the current distribution is also caused by
• bundled conductors
• ferranti effect
• proximity effect
• all of the above

### Question 4

Question
Transmission lines are transposed to reduce
• interference with neighbouring communication lines
• ferranti effect
• proximity effect
• skin effect

### Question 5

Question
In transmission lines distribution constants are
• inductance and capacitance
• resistance
• inductance and resistance
• both 1 and 2

### Question 6

Question
Aluminium is now most commonly employed conductor material in transmission lines than copper because
• it is more conductive
• its tensile strength is more
• costlier
• it is cheaper and lighter

### Question 7

Question
ACSR means
• Aluminium core steel reinforced
• Aluminium conductor steel reinforced
• Aluminium copper steel reinforced
• all conductor steel reinforced

### Question 8

Question
The inductance of single phase two wire line is given by
• 4*10-7* ln(d/r') H/m
• 4*10-7* ln(r'/d) H/m
• 0.4*10-7* ln(d/r') H/m
• 0.4*10-7* ln(r'/d) H/m

### Question 9

Question
If the diameter of the conductor is increased
• the inductance is increased
• the inductance is decreased
• the resistance is increased
• no change in inductance and resistance

### Question 10

Question
Which of the following statements is/are true
• Voltage regulation for short transmission line = (Vs - Vr) / Vr
• Voltage regulation for medium transmission line = (Vs - Vr) / Vr
• Voltage regulation for long transmission line = (Vs - Vr) / Vr
• all of the above

### Question 11

Question
The ABCD constants of a 3-phase transmission line are A = D = 0.8∠1°, B = 170∠85° Ω , C = 0.002∠90.4° â„§. The sending end voltage is 400 kV. The receiving end voltage under no load condition is
• 400 kV
• 500 kV
• 600 kV
• 350 kV

### Question 12

Question
Surge impedance loading of a 3-phase, 400 kV transmission line is 400 Ω. The surge impedance loading is
• 400 MW
• 800 MW
• 1600 MW
• 200 MW

### Question 13

Question
Surge impedance loading of a transmission line can be increased by
• increasing its voltage level
• addition of lumped inductance in parallel
• addition of lumped capacitance in series
• both 1 and 3

### Question 14

Question
For transmission line which one of the following relation is true?
• AD - BC = 0
• AD + BC = 0
• AD - BC = 1
• AD - BC = -1

### Question 15

Question
A 3-phase transmission line has its conductors at the corners of an equilateral triangle with side 3m. The diameter of each conductor is 1.63 cm. The inductance of the line per phase per km is
• 1.093 mH
• 1.043 mH
• 1.182 mH
• 1.232 mH

### Question 16

Question
In series RLC circuit which of the following represents the Q factor ?
• XC/R
• VR/V
• XL/R
• All of the above

### Question 17

Question
In series RLC circuit what is the power factor just bellow the resonance frequency?
• Lagging
• Unity
• Zero

### Question 18

Question
Which of the following represents the resonance frequency (ω0) with respect to lower cutoff frequency (ω1) and higher cutoff frequency (ω2)
• ω1 + ω2
• ω1 - ω2
• ω1 / ω2
• √(ω1² + ω2²)

### Question 19

Question
In a series resonance circuit if bandwidth is 1 MHz and inductance is 1 mH, then what is the resistance value?
• 1 KΩ
• 1 MΩ
• 1 Ω
• 100 Ω

### Question 20

Question
Time constant of RL series circuit is
• 2L/R
• RC
• L/R
• 2RC

### Question 21

Question
Time constant is the time taken for response to rise -------of maximum value?
• 63.2%
• 100%
• 90%
• 68.3%

### Question 22

Question
In which of the following oscillations are not present?
• Under damping
• Over damping
• Critical damping
• Both 2 and 3

### Question 23

Question
In RLC series circuit R=2Ω, L=2mH and C=1μF and applied voltage is 10V dc. Then what is steady state current value?
• 5A
• 2A
• 1A
• 0A

### Question 24

Question
Image impedance can be written by using short circuit impedance(Zsc)and open circuit impedance(Zoc) as
• Zsc+Zoc
• Zsc-Zoc
• Zsc/Zoc
• (Zsc . Zoc)½

### Question 25

Question
Poles and zeros are arranged alternatively on imaginary axis, then type of network is?
• RLC network
• LC network
• RC network
• RL network

### Question 26

Question
In ideal system coefficient of coupling(k) is
• 0
• 1
• 1 & ∞ Both

### Question 27

Question
Basic cut set matrix consists of
• one branch
• no branches
• 2 branch
• any number of branches

### Question 28

Question
Active filter consists of
• Capacitor
• Inductor
• op-amp and capacitor
• op-amp

### Question 29

Question
Reciprocity condition for h parameters is
• h12 = h21
• h12 = -h21
• h11h22 - h21h12 = 0
• h11 = h22

### Question 30

Question
A pole of driving point impedance is
• Zero current for a finite value of driving voltage
• Zero voltage for a finite value of driving current
• Zero voltage for a finite value of driving voltage
• Zero current for a finite value of driving current

### Similar

Bsnl Academy MCQ on Measurement Pdf
BSNL TTA ONLINE TEST - 6 Basic Electricity - 3
Bsnl TTA Test Series Time Table
Cold War (1945-1975)
One child policy, China- Population Control Case Study
French -> small but important words for GCSE
Prática para o TOEFL
Key word flashcards
AQA GCSE Physics Unit 2
Carbohydrates
el centro comercial