Changing the way you learn

Question 1

Question

You can use these to combine two wires, they are often used in electrical work.

Answer

Long Nose Pliers
Combination Pliers

Question 2

Question

It is the action of join two materials by deforming one of them through the use of a force.

Answer

To crimp
To cut
To screw

Question 3

Question

This is a Phillips Screwdriver

Image:

1ddddfd8-137a-467b-8865-732b93f8c6eb (image/jpeg)

Answer

True
False

Question 4

Question

Long Nose Pliers

Answer

Question 5

Question

I use this tool to cut the end of the wires before crimping them into an RJ-45 connector.

Answer

Question 6

Question

These tools are used to carefully put or extract little electronic components.

Image:

249f07b1-3403-4e3a-9396-c5e0260a2abf (image/jpeg)

Answer

True
False

Question 7

Question

This tool is used to tighten or loosen flathead screws.

Answer

Slotted screws
Flat screwdriver
Hex screwdriver

Question 8

Question

Slotted screw

Answer

Question 9

Question

This tool is used to insulate a wire.

Image:

0a3ee135-5b45-4324-9cb5-c7539e29cd16 (image/jpeg)

Answer

True
False

Question 10

Question

This tool is used to crimp a kind of connector with a wire.

Answer

Question 11

Question

These are cutting tools. (Select three)

Answer

Question 12

Question

This is used to avoid an electrical discharge when working on elecronic components.

Image:

4886a57e-b38a-472a-b0fc-790c60a640a0 (image/jpeg)

Answer

True
False

Question 13

Question

Tools used to tighten and loosen nuts and bolts. (Select two)

Answer

Question 14

Question

Torque wrench

Image:

2a5924ed-c25e-4ebe-b9a4-e1ce53a5d225 (image/jpeg)

Answer

True
False

Question 15

Question

The action of dividing something into smaller pieces.

Answer

To crimp
To cut
To tight

Question 16

Question

What is the first step to solder?

Answer

Heat the soldering iron.
Make sure the tip is clean.
Put the components together.

Question 17

Question

After soldering, the soldering iron should be held for another second to melt the solder before retiring it.

Answer

True
False

Question 18

Question

If you have a mistake you can remove it by using a [blank_start]desoldering tool[blank_end].

Answer

desoldering tool
flux
soldering tip
component

Question 19

Question

It is important to heat the soldering iron so the solder can be [blank_start]melted[blank_end] on the two components which are going to be bonded.

Answer

melted
melt
melting
didn't melt

Next up

Test 2 Tools

Description

Resource summary

Question 1

Question 2

Question 3

Question 4

Question 5

Question 6

Question 7

Question 8

Question 9

Question 10

Question 11

Question 12

Question 13

Question 14

Question 15

Question 16

Question 17

Question 18

Question 19

Similar

	Created by Miguel Ángel Martínez Lara over 7 years ago