Flussdiagramm
Ohne Titel

Flowchart: copper compound experiment
Inhalt des Flussdiagramms
Experiment 2
Weight Crucible, Add 1g of unknown copper compound. Record exact mass to 3 decimal places
Heat it to drive off water by hydration. Use tongs and stir with glass rod. Record observations
Heat until color change is gone, cool on bench-top, Weigh remaining sample
Transfer contents to 250mL beaker. Rinse with DH2O into crucible to remove product into beaker and make volume to 50mL
Part B
In 10mL graduated cylinder, obtain 2mL of 6M HCl and add it to beaker. STIR till dissolved. Cover with watch glass when not stirring
Find mass of Mg required in (excess) to convert Cu(2+) to Cu(s). Use a 50mL beaker to weigh required Mg
Add Mg to beaker, stir. Continue until the solution is clear
In a 10mL graduated cylinder obtain 6mL of 6M HCl and add to the beaker to dissolve excess Mg. Stir until dissolved and hydrogen gas has ceased. COVER BEAKER WITH WATCH GLASS WHEN NOT STIRRING
Position weighed filter paper in centre of funnel, turn on vacuum, and wet paper with small amount of DH2O to make seal
Decant the acidic water into funnel without disturbing copper settled to bottom. Use DH2O wash bottle to rinse copper solids from beaker into funnel
Wash copper solids collected in filter paper three times with small amounts of DH2O. Allow vacuum to suction air through filter a few times linger in order to remove moisture from copper and filter paper
Use spatula to transfer filter paper with copper residue to pre-weighed watch glass and place it in the drying oven for 10 minutes. Cool to room temp and re-weigh to obtain mass of copper
Informationen
- Beschreibung
- Flussdiagramm am Ohne Titel, erstellt von Philip Nguyen am 27/09/2018.
- Erstellt von
- Philip Nguyen
- Aufrufe
- 0
- Bewertung