LAFFE WORK

Start

Labelling out the required measurements using a ruler, pencil and tri-square on the raw material

Cutting out the required design for the material using scroll saw

Using chloroform, the pieces of acrylic is stuck together

Clamp the acrylic securely on the lathe machine.

Are the acrylics of the same alignment?

NO

Begin cutting the acrylic using the lathe machine

YES

Is the correct diameter acheived?

Is a centre hole in the acrylic required?

Start drilling the hole on the material using the lathe machine and accurate drill size

YES

Is the hole diameter of the correct size?

NO

Use a dry and wet sandpaper to remove the fine marks at the edge of the acrylic

Are all the fine marks removed?

NO

NO

NO

Start polishing the edge for shining on the lathe machine

YES

Check if all ages are shined?

NO

This part of the artefact is completed.

End