Olvl Flowchart 1

Start

Delineate the needed measurements of my design using a pencil,ruler and tri-square on a raw piece of acrylic material

Cut out the acrylic piece using the marked out markings using the scroll machine

Carve the design on the materials using the disc sander machine and hand file

Is the carved out piece to the design of planned

NO

Does the piece require any drilling using the drilling machine

Remove unwanted markings on the edges of the acrylic using the hand file

Drill out the holes on the acrylic piece using the drilling machine and the correct bit size for the required hole size

Is the drilled hole to the correct size?

Are all the unwanted marks removed?

Use the wet sand paper to remove all the fine marks on the sides and edges of the acrylic piece

Are all the fine markings removed?

Burnish the edges using a buffing machine and autosol

Are all the edges and sides shinny?

Is there any part needed to be bent using a strip heater

Soften the acrylic piece using the strip heater

Is the bending of the piece correct?

The making of the part for the artefact is completed

End

YES

NO

YES

NO

YES

NO

YES

NO

YES

NO

YES

NO