Dawson china number 2

start

mark out all the necessary measurements of my design using a steel ruler, pencil and tri-square on a raw acrylic material.

use chloroform to glue all the necessary pieces of acrylic together.

clamp all the acrylic pieces together on the lathe machine

cut out the initial design on the acrylic using scroll saw.

are all the acrylics aligned

properly, safely and correctly?

NO

start cutting the acrylic piece on the lathe machine

Use a dry-and-wet sandpaper to remove all the fine markings on the edges of the acrylic

YES

is the necessary diameter

for the acrylic obtained?

NO

is there a need to drill a

hole in the center of the acrylic

YES

drill holes on the acrylic using the lathe machine and using the correct drill size bit

YES

NO

is the diameter of the hole correct?

YES

NO

are all the fine markings removed

from the acrylic piece

NO

Polish the acrylic edges until it shines on the lathe machine

are all the edges of the acrylic

polished and shined

The making of this part of the final artefact is done.

YES

NO

End

2