jo

Start

Point out the critical measurements of mark product using a steel ruler, pencil and tri-square on the raw acrylic material

Cut out the design of the product on the materials using the scroll machine

chloroform all the pieces of acrylic together

Clamp all the pieces of acrylic together onto the lathe machine

Is the acrylic pieces aligned properly and accurately?

Start by cutting the acrylic on the lathe machine

Is it required to drill a middle hole in the acrylic?

Drill a hole on the materials on the lathe machine by using the correct drill bit size

Is the hole diameter is right?

Use dry paper to take out all the fine scratch marks on the edges of the acrylic pieces​

Are all the fine marks on the edges of the acrylic has been taken out?

Polish the edges of the acrylic to shine brightly on the lathe machine

Are all the edges of the acrylic shinned?

The making of the part of the artefact has been completed

End

Is the needed diameter of acrylic is held?