Automatic Controller of Water

Automatic Controller of Water

1. ELEMENTS

   • Arduino UNO Recistences Transistor Diode Diode-led Motor-pump
     • l{,

2. ¿WHAT IS?

   • Is a Circuit that helps to control the storage of water

3. PROYECT DEVELOPMENT

   • Schematic Diagram in Proteus
     • Printed Circuit
       • Toweld the Elements

4. WORKING

   • When the water is in the high level the motor-pump lets of providing water and when is to a low level the motor-pump allows the water step.

5. USES

   • This system is very useful in the tank and sink
     • Protect the house of positive damage

6. CONNECT

   • THE ARDUINO
     • Connect pin 4 to resistor "1k"
     • Connect positive to resistor "22k"
     • Connect Pin 11, 12 and 13 to three resistor "470"
     • Connect Pin 8, 9 and 10 to three transistor
   • TRANSISTOR
     • Connect pin 3 to negative and resistor "220k"
     • Connect pin 2 to resistor "220k" and a cable that the measures level
     • Connect pin 1 to resistor "470" and Arduino
   • DiISPLAY
     • Connect pin A to pin 7 in the Arduino
     • Connect pin BC to pin 6 in the Arduino
     • Connect pin A1 to pin 5 in the Arduino
     • Connect pin 4 to pin 4 in the Arduino

Bilder und Dateien der Mindmap