9. Lab 293 CCNA

Seite 1

Central Florida Widgets recently installed a new router in their office.

Complete the network installation by performing the initial router configurations and configuring R1PV2 routing

using the router command line interface (CLI) on the RC.

Configure the router per the following requirements:

Name of the router is R2

Enable. secret password is cisco

The password to access user EXEC mode using the console is cisco2

The password to allow telnet access to the router is cisco3

IPV4 addresses must be configured as follows:

Ethernet network 209.165.201.0/27 - router has fourth assignable host address in subnet

Serial network is 192.0.2.176/28 - router has last assignable host address in the subnet.

Interfaces should be enabled.

Router protocol is RIPV2

Attention:

In practical examinations, please note the following, the actual information will prevail.

1. Name or the router is xxx

2. Enable. secret password is xxx

3. Password In access user EXEC mode using the console is xxx

4. The password to allow telnet access to the router is xxx

5. IP information

Seite 2

Answer:

Router>enable

Router#config terminal

Router(config)#hostname R2

R2(config)#enable secret Cisco 1

R2(config)#line console 0

R2(config-line)#password Cisco 2

R2(config-line)#exit

R2(config)#line vty 0 4

R2(config-line)#password Cisco 3

R2(config-line)#login

R2(config-line)#exit

R2(config)#interface faO/0

R2(config-if)#ip address 209.165.201.4 255.255.255.224

R2(config)#interface s0/0/0

R2(config-if)#ip address 192.0.2.190 255.255.255.240

R2(config-if)#no shutdown

R2(config-if)#exit

R2(config)#router rip

R2(config-router)#version 2

R2(config-router)#network 209.165.201.0

R2(config-router)#network 192.0.2.176

R2(config-router)#end

R2#copy run start