Karteikarten
Climate Models

Karten in diesem Stapel (29)
- 1The energy flux (amount of radiation emitted in W-2m) differs between the top of the atmosphere (239 W-2m ) and the lower atmosphere (342 W-2m). Why is this?this is because the energy flux is dependent on the temperature (upper vs lower atmosphere)
- 2What is Earth's average temperature?15C
- 3If we build “energy balance models” to simulate climate, they will compute and compare energy inflows and outflows. How do we estimate temperature from energy outflow?

- 4We will focus on energy balance models which assume that energy inflows must equal energy outflows. If no sun was shining on the earth, what would earth’s temperature be?32 K (-241 C, -402 F)
- 5Assume there were no greenhouse gases in the atmosphere. If the sun shone on the earth (input of 340 W-2m) and an equal amount of energy was emitted from earth, what would earth’s temperature be?278 K (5 C, 41 F)
- 6If 30% of the incoming solar radiation was reflected off ice on the earth’s surface, and there were no greenhouse gases in the atmosphere, explain what would happen to earth’s temperature255 K (-18 C, -0.4 F)
- 7If the atmosphere contained greenhouse gases that were emitting 238 W m -2 back to space, explain how this would affect earth’s temperature303 K (30 C, 86 F)
- 8Explain the 5 steps used to develop climate models1. Develop equations that represent processes (e.g., energy flows) in the climate system.
2. Solve the equations on a computer by grid segments which represent a latitude longitude-height cell for the atmosphere and ocean.
3. Parameterization: approximate complicated processes (cloud formation), and processes that occur sporadically (volcanic eruption, hurricanes).
4. Compare predictions to observations
5. Adjust model components to bring predictions closer to observations. - 9Define the following abbreviations: FAR, SAR, TAR, and AR4FAR = First Assessment Report
SAR = Second Assessment Report
TAR = Third Assessment Report
AR4 = Fourth Assessment Report - 10The IPCC uses models that compute temperature by grids placed over the earth’s surface and that extend into the atmosphere. Why is temperature computed by grids?provides a continuous and comprehensive and standardized measurement while also giving spatial representation
- 11List the three major types of climate models available, and explain how each is used. Which model is considered the “state of the art” because it is most complex?

- 12Approximately how many different climate models are available?100+
- 13What is the Climate Model Intercomparison Project (CMIP5)?uses 50+ modeling groups to run the same experiments and run results
- 14Explain what a “multimodel ensemble” is. How is such an ensemble used for hurricane-path predictions.results that are averaged over time and compared to observations form this ensemble
- 15What kinds of experiments will be conducted in the CMIP5 project?carbon cycle evaluation, climate sensitivity feedback, etc.
- 16Model ensembles are used to make predictions of global temperature using two different kinds of inputs. What are considered for the models using “natural inputs”?volcanoes & sun
- 17Following along with the above, what inputs do the models use for the “Anthropogenic and Natural” inputs.GHGs & sulfates
- 18The models mentioned above produce different results. How do we know which results are most accurate?we can see predictions of different combinations of models and observe which matches our known data the best
- 19If models that include human impacts on climate agree with observations, but models without human impacts do not agree with observations, then what can we conclude?humans are changing the climate
- 20What processes are producing variability in the climate record?global surface temps, solar cycles, volcanoes, internal variability (el nino), and anthropogenic (includes GHGs)
- 21To predict global temperatures into the future, the models have to make certain assumptions. The way they do this has changed between the last two IPCC reports (AR4 and AR5). Explain what “Socio-Economic Scenarios” are, and list the abbreviations associated with them

- 22Explain what “Representative Concentration Pathways (RCPs)” are and include how they are determined?4 GHG concentration trajectories used for climate modeling and research (tracks previous trajectory trends and tries to make predictions)
- 23What is Radiative Forcing? If the incoming radiation at the top of the atmosphere was 340 W-2m, and the outgoing radiation was 330 W-2m, what would the radiative forcing be?the change in the Earth's energy balance
10W/m2 - 24Explain what an RCP of 8.5 means? Which RCP is closer to having an energy balance: 8.5 or 2.6? Which RCP would produce warmer temperatures?Representative Concentration Pathway - describes different possible future greenhouse gas concentrations
8.5 = higher warming scenario - 25Considering model predictions that have been made, is there an RCP value that would produce a drop in global temperature by 2100? If so, which one?the RCP2.6 plan should slightly drop global temp by 2100
(nothing is guaranteed as the future is dependent on GHG emissions) - 26Assume our atmosphere has about 400 ppm of CO2 gas in it today. What would the predicted concentrations of CO2 gas be for the year 2100 under RCPs of: 2.6, 4.5, 6, and 8.5?RCP2.6 = 420ppm
RCP4.5 = 540ppm
RCP6.0 = 670ppm
RCP8.5 = 935ppm - 27If we wanted to keep global temperature increases below a 2 C by 2100 from where they are now, what RCPs would we have to try and attain? How much rise in temperature would we expect in 2100 for an RCP of 8.5?RCP2.6 or 4.5
deltaT = 3.7 degC - 28Which portions of the earth are expected to experience the greatest changes in temperature by 2100?artic(poles), inner regions of large landmasses, and deep oceans
- 29Explain how the soil moisture in NC is expected to change by 2100 for RCPs of 2.6 and 8.5RCP2.6: 0.2
RCP8.5: -0.8
Informationen
- Beschreibung
- Undergrad ES200 (Exam 1) Karteikarten am Climate Models, erstellt von Kaia Andrews am 05/02/2026.
- Erstellt von
- Kaia Andrews
- Aufrufe
- 1
- Bewertung