¡GoConqr estrena diseño! Cuéntanos qué te parece.

Regístrate gratis

Test

Flow of Fluids Quiz no. 1 Ramirez

Nicolle Katherine 10 preguntas

Hacer el test

Preguntas del test (10)

  1. 1A jet aircraft flies at a speed of 550 mph at an altitude of 35 000 ft., where the temperature is -66deg F. Determine the ratio of the aircraft, v to that of the speed of sound, c at the specified altitude. Assume k=1.40.
    1. A13.71
    2. B11.91
    3. C0.829
    4. D0.874
  2. 2Two water streams at 15 °C, one flowing at 3 kg s -1 and another flowing at 2 kg s -1 , discharge into a tank at steady state. The tank has an exit pipe (inside diameter = 100 mm), which is connected to a horizontally oriented nozzle that discharges the water through a tube with an inside diameter of 4 mm. What is the flow rate of the water stream in the tube after it passes the nozzle (ft/s).
    1. A1306.8 ft/s
    2. B0.016 ft/s
    3. C0.1306 ft/s
    4. D16.02 ft/s
  3. 3What will be the rated capacity (gpm) of a 5 inch diameter impeller centrifugal pump operating at a speed of 3450 rpm capable of generating a head of 80 ft. water?
    1. A111
    2. B222
    3. C44
    4. D123
  4. 4What is the power requirement of a fan in kW in order to supply air at a rate of 1500 m3/hr at a total discharge pressure of 10.35 kPa?
    1. A0.431
    2. B43.1
    3. C4.31
    4. D0.0431
  5. 5A differential pressure gauge is connected across the taps of a pitot tube. When this pitot tube is used in wind tunnel test the gauge indicates a change in pressure of 730 Pa. What is the air velocity in the tunnel given that the pressure and temperature in the tunnel are 98 kPa and 20 deg Celsius
    1. A0.353 m/s
    2. B353 m/s
    3. C3.53 m/s
    4. D35.3 m/s
  6. 6A venture meter is to be installed in a 100 mm diameter pipe to measure the flow of water. The maximum flow rate is expected to be 75m3/hr at 15deg C. The manometer used to measure the differential pressure is to be filled with mercury and water, is to fill the leads above the surfaces of the mercury. The water temperature will be 15 deg C throughout. If the maximum manometer reading is to be 1.25 m and the venture coefficient is 0.98. What throat diameter(mm) should be specified for the venturi?
    1. A39.2
    2. B0.39
    3. C3.9
    4. D0.0392
  7. 7Water is pumped to the top of a covered tank, elevated 50 m from the centerline of the pump. If the water entered the pump at a pressure of 100 kPa through a 2-inch sch. 40 steel pipe and delivered at 350 kPa through the same pipe size to the elevated tank, how long will it take for the 2-horsepower pump to fill the 20-m 3 tank?
    1. A0.0275 h
    2. B16.6 min
    3. C0.275 h
    4. D165. 22 min
  8. 8Pick out the wrong statement.
    1. AThe form drag is dependent upon the occurrence of a wake.
    2. BThe shear stress at any given cross-section of a pipe for steady flow (either laminar or turbulent) varies linearly as the radial distance.
    3. CExistence of the boundary layer in fluid flow is because of viscosity of the fluid
    4. DAn ideal fluid is the one, which has negligible surface tension and obeys the Newton's law of viscosity.
  9. 9The ratio of inertial forces to elastic forces is called the __________ number.
    1. AReynolds
    2. BEuler
    3. CMach
    4. DWeber
  10. 10Theoretical head developed by a centrifugal pump does not depend upon the __________ the impeller.
    1. Aradius of
    2. Bspeed of
    3. Cfluid velocity leaving
    4. Dnone of these

Información

Descripción
Fluid mechanics Test sobre Flow of Fluids Quiz no. 1 Ramirez, creado por Nicolle Katherine el 23/07/2015.
Idioma
English
Visitas
41
Valoración
Aún sin valoraciones
Valora este test
Valora este test

Escríbenos

¿Sobre qué es tu mensaje?

¿Qué te parece el nuevo diseño?

¿Te gusta?