Fichas
4.2 Pressure and Density
Fichas del conjunto (43)
- 1define barometric tendancyway and the rate of which pressure changes
- 2What happens when isobars are close togetheryou get strong winds
- 3what happens when isobars are far apartyou get calmer or no winds
- 4how can you tell if an area has low pressurethe isobars pressure decreases as you go intowards towards the centre
- 5how can you tell if the isoabrs are representing a high pressure areathe isobars increase in pressure iwards, towards the centre
- 6what weather is associated with high pressureanticyclones
nice weather - 7what weather is associated with low pressurepoor weather systems
- 8define a colan area between x2 high pressure systems and x2 low pressure systems
- 9what characteristics are associated with a col in summerthunderstorms
- 10what characteristics are associated with a col in winterfog
- 11what does FPS stand forFlat pressure systems
- 12is 500 hpa higher or lower in warm air than standard ISA temperatures?higher
- 13is 500 hpa higher or lower in cold air than standard ISA temperatures?lower
- 14what are Hypohypseslines on a 3D weather chart indicated areas of the same pressures at different heights
- 15define densitymass of air per unit volume
- 16what are the units of densityg/m3
- 17density does what with an increase in heightdecrease
- 18density does what with an increase in pressureincreases
- 19density does what with a increase in temperaturedecrease
- 20density does what what with a increase in humiditydecreases
- 21what has the biggest effect on densitypressure
- 22what type of density is optimal for flighthigh density
- 23what can low density causereduction in :
engine performance
lift
fuel consumption
accuracy of aircraft pressure instruments - 24at what altitude is density the same26 000 ft
- 25where does half density occur20 000ft
- 26where do u find high density low or high groundlow
- 27where do u find high density high or low temperaturelow temp
- 28where do u find high density high or low humiditylow
- 29what can you say about density in relation to the diurnal variation against temperature graphdensity is inversely proportional to temperature
- 30what can you say about the density when there is a "high density Altitude"density is low
- 31what can you say about density when there is a "Low density Altitude"density is high
- 32define Relative densityambient air density compared to the density of the ISA MSL air
- 33what is the formula for density altitudeDA = PA + (120 x ISA Deviation)
- 34what is the pressure altitudetaken from the Standard pressure setting
- 35what is SPSStandard Pressure setting
- 36what is the SPS1013.25 HPA
- 37what is the name of the place where you go from using Altitude to FLTransition altitude
- 38what is the name of the place where you go from FL to AltitudeTransition Level
- 39where does the QNH measure frommean sea level using ISA lapse rate
- 40where does QFE measure fromelevation above sea level
- 41what is QFFmean sea level using ambient lapse rate
- 42what is QNEwhere u get told the altitude that the Altimeter will read at the aerodrome, and therefore can work out your actual height by taking this value away. usually used when you cannot set the subscale as low as it pressure at the aerodrome
- 43what is the density at MSL1.225 m/g3
Información
- Descripción
- MET Fichas sobre 4.2 Pressure and Density, creado por Ella Davies el 15/02/2018.
- Creado por
- Ella Davies
- Visitas
- 3
- Valoración
Más sobre The Atmosphere and Standard Atmosphere