Mapa mental
River processes: drainage basin terms, erosion and transport

Contenido del mapa
Rivers
Definitions
- Drainage basin - the area of land drained by a river.
- Catchment area - the area within the drainage basin.
- Watershed - the edge of highland surrounding a drainage basin. It marks the boundary between two drainage basins.
- Source - The beginning or start of a river
- Confluence - the point at which two rivers or streams join.
- Tributary - a stream or smaller river which joins a larger stream or river.
- Mouth - the point where the river comes to the end, usually when entering a sea.
River processes
- Erosion
- Erosion involves the wearing away of rock and soil found along the river bed and banks. Erosion also involves the breaking down of the rock particles being carried downstream by the river.
- Main types
- Hydraulic action - the force of the river against the banks can cause air to be trapped in cracks and crevices. The pressure weakens the banks and gradually wears it away.
- Abrasion - rocks carried along by the river wear down the river bed and banks.
- Attrition - rocks being carried by the river smash together and break into smaller, smoother and rounder particles.
- Solution - soluble particles are dissolved into the river.
- Transport
- Main types
- Solution - minerals are dissolved in the water and carried along in solution.
- Suspension - fine light material is carried along in the water.
- Saltation - small pebbles and stones are bounced along the river bed.
- Traction - large boulders and rocks are rolled along the river bed.
- Rivers pick up and carry material as they flow downstream.
- When energy levels are very high, large rocks and boulders can be transported. Energy levels are usually higher near a river's source, when its course is steep and its valley narrow. Energy levels rise even higher in times of flood.
- When energy levels are low, only small particles can be transported (if any). Energy levels are lowest when velocity drops as a river enters a lake or sea (at the mouth).
- Main types
- Deposition
- Deposition may take place when a river enters an area of shallow water or when the volume of water decreases - for example, after a flood or during times of drought.
- Deposition is common towards the end of a river's journey, at the mouth.
- Deposition at the mouth of a river can form deltas - for example, the Mississippi Delta.
- Erosion
River landforms
- Upper course
- Upper-course river features include steep-sided V-shaped valleys, interlocking spurs, rapids, waterfalls and gorges.
- As the river moves through the upper course it cuts downwards. The gradient here is steep and the river channel is narrow. Vertical erosion in this highland part of the river helps to create steep-sided V-shaped valleys, interlocking spurs, rapids, waterfalls and gorges.
- As the river erodes the landscape in the upper course, it winds and bends to avoid areas of hard rock. This creates interlocking spurs, which look a bit like the interlocking parts of a zip.
- When a river runs over alternating layers of hard and soft rock, rapids and waterfalls may form.
- Middle course
- Meanders
- As the river erodes laterally, to the right side then the left side, it forms large bends, and then horseshoe-like loops called meanders.
- The formation of meanders is due to both deposition and erosion and meanders gradually migrate downstream.
- The force of the water erodes and undercuts the river bank on the outside of the bend where water flow has most energy due to decreased friction.
- On the inside of the bend, where the river flow is slower, material is deposited, as there is more friction.
- Over time the horseshoe become tighter, until the ends become very close together. As the river breaks through, eg during a flood when the river has a higher discharge and more energy, and the ends join, the loop is cut-off from the main channel. The cut-off loop is called an oxbow lake.
- In the middle course the river has more energy and a high volume of water. The gradient here is gentle and lateral (sideways) erosion has widened the river channel. The river channel has also deepened. A larger river channel means there is less friction, so the water flows faster:
- Meanders
- Lower course
- In the lower course, the river has a high volume and a large discharge. The river channel is now deep and wide and the landscape around it is flat. However, as a river reaches the end of its journey, energy levels are low and deposition takes place.
- Floodpains
- The river now has a wide floodplain. A floodplain is the area around a river that is covered in times of flood. A floodplain is a very fertile area due to the rich alluvium deposited by floodwaters. This makes floodplains a good place for agriculture. A build up of alluvium on the banks of a river can create levees, which raise the river bank.
- Delta
- Deltas are found at the mouth of large rivers - for example, the Mississippi. A delta is formed when the river deposits its material faster than the sea can remove it. There are three main types of delta, named after the shape they create:
- Arcuate or fan-shaped - the land around the river mouth arches out into the sea and the river splits many times on the way to the sea, creating a fan effect.
- Cuspate - the land around the mouth of the river juts out arrow-like into the sea.
- Bird's foot - the river splits on the way to the sea, each part of the river juts out into the sea, rather like a bird's foot.
- Upper course
Imágenes y archivos del mapa
Información
- Descripción
- Mapa Mental sobre Sin título, creado por Finn Hartley el 25/11/2014.
- Creado por
- Finn Hartley
- Visitas
- 2
- Valoración
