Test
chapter 27 drill press
Este test tiene tipos de pregunta que se abren en el reproductor de siempre.
Preguntas del test (12)
1a bit used to cut cross-grain plugs and dowels is known as a [blank_start]plug cutter[blank_end]
- Atwist cut
- Bplug cutter
- Ccolumn
2the [blank_start]depth guage[blank_end] or stop controls how far the drill bit or cutting tool can move
- Adepth guage
- Bv block
- Cstopper
3use a [blank_start]twist drill[blank_end] holes that are 1\4 inch smaller
- Aplug
- Btwist drill
- Cpushstick
4when used at a proper speed a drill press can be used for sanding
- AVerdadero
- BFalso
5on machines with a step pulleys the speed is set by the way the belt is arranged on the pulleys
- AVerdadero
- BFalso
6you should always turn the power off before adjusting the depth stop
- AVerdadero
- BFalso
7an [blank_start]adjustable screw pilot bit[blank_end] installs and countersinks flathead screws
- Aadjustable screw pilot bit
- Bcountersink bit
- Cfly cutter
8a [blank_start]spade bit[blank_end] is a fast cutting bit that leaves rather rough holes
- Ahole saw
- Bspade bit
- Cfly cutter
9a [blank_start]multispur bit[blank_end] cuts perfectly round flat bottomed holes
- Abradpoint bit
- Bcountersink bit
- Cmultispur bit
10a drill bit surrounded by a four sided chisel is a [blank_start]mortising attachment[blank_end]
- Afly cutter
- Badjustable screw pilot bit
- Cmortising attachment
11this cuts circular holes from 1 to 4 inches in diameter is a [blank_start]fly cutter[blank_end]
- Abrad point
- Bfly cutter
- Cspade
12to drill a hole in round stock you should first place the stock in a [blank_start]v-block[blank_end]
- Ac-block
- Bv-block
- Cd-block
Información
- Descripción
- Test sobre chapter 27 drill press, creado por Lisa Praught el 14/12/2017.
- Autor
- Lisa Praught
- Idioma
- English
- Visitas
- 2
- Etiquetas
- Valoración
- Aún sin valoraciones Valora este test