Test
Senior Design Chapter 10: Design for X; Faiure, Safety, Tolerances, and Environment
Preguntas del test (15)
1In the failure modes and effect analysis method, the reason why a part fails owing to a defect in design or manufacture is called the...
- Aeffect
- Bcause
- Cseverity
- Ddetection
2The adverse consequences that the customer might experience is called....
- Aseverity
- Bcauses
- Ceffects
- Ddetection
3The risk priority number(RPN) is the product of the following factors except...
- Aseverity rating
- Bdefect rating
- Coccurance rating
- Ddetection rating
4All of the following are examples of prevailing part failure modes except...
- Abinding
- Brotating
- Cleaking
- Dfracturing
5What "likelihood" would rate a 10 on the occurance rating chart?
- Aoccasional
- Bremote
- Cexpected
- Dimprobable
6At what stage in the life of a product may injuries occur to employees or customers? (select all that apply)
- Amanufacture
- Buse
- Cretirement
- DCAD hand cramps
7Injuries received by touching hot surfaces, sharp edges or electrically charged parts are caused by...
- Acontact hazards
- Bentrapment hazards
- Cimpact hazards
- Dentanglement hazards
- Estupidity hazards
8Injuries received from hammer blows are called...
- Acontact hazards
- Bimpact hazards
- Cejection hazards
- Dentanglement hazards
9The design method that establishes priorities for risk reduction is called...
- Asafety alternatives
- Bhazard reduction
- Csafety hierarchy
- Dhazard hierarchy
10The fundamental design principles used to design safe products and systems include all of the following except...
- Adual use
- Bsafe life
- Creduction design
- Dfail safe
11Particles flung from moving machinery parts are called...
- Acontact hazards
- Bimpact hazards
- Cejection hazards
- Dkinetic hazards
12Legal actions taken to recover damages for personal injury or physical damage to property are called...
- Acivil actions
- Bcriminal actions
- Cproduct liability actions
- Dlegal proceedings
13The Occupational Safety and Health Act (OSHA) protects...
- Avendors
- Bemployees
- Cshippers
- Dcustomers
14The highest priority design effort should be to...
- Aprovide training
- Bprotect against the hazards
- Celiminate the hazards
- Dprovide warnings
15Which type of fit sepcifies a deliberate space between mating parts...
- Ainterference fit
- Bworst case fit
- Cclearance fit
- Dstatistical fit
Información
- Descripción
- Chapter 10 senior design
- Autor
- nep2112
- Idioma
- English
- Visitas
- 142
- Etiquetas
- Valoración
- Aún sin valoraciones Valora este test