Ayúdanos a dar forma a GoConqr. ¿Qué deberíamos añadir?

Test

Ch. 7 Study Exam

Darion Ward 13 preguntas

Hacer el test

Preguntas del test (13)

  1. 1Which of the following is a reason to create VLANs?
    1. AVLANs provide better security by separating groups of users and their devices and message traffic.
    2. BVLANs can segment broadcast domains without using a router.
    3. CVLANs allow you to forward traffic between networks without a router.
    4. DVLANs can improve performance on hosts, reducing their processing overhead by limiting the broadcast messages and separating traffic types.
  2. 2Which protocol is standard for tagged VLANs over trunks?
    1. AVLAN Trunking Protocol
    2. B802.1D
    3. CDynamic Trunking Protocol (DTP)
    4. D802.1Q
    5. ENone of the above
  3. 3Which VLAN must always be VLAN 1?
    1. AThe static VLAN
    2. BThe native VLAN
    3. CThe default VLAN
    4. DThe Layer 2 VLAN
  4. 4Which command is used to add interfaces to VLAN 5?
    1. Aswitchport access vlan 5 on each interface
    2. Bswitchport access vlan 5 in Global Configuration mode, followed by interface range x - y
    3. Cswitchport access vlan 5 interface range 0 – 24
    4. DNone of the above
  5. 5Which command(s) can be used to view VLAN membership for all VLANs on the switch?
    1. Ashow vlan brief
    2. Bshow membership vlan
    3. Cshow running-config
    4. DNone of the above
  6. 6Which command is used to add interfaces to VLAN 5?
    1. Aswitchport mode trunk vlans All
    2. Bswitchport mode trunk in Global Configuration mode
    3. Cswitchport mode trunk on each interface
    4. DNone of the above
  7. 7Which command(s) can be used to verify your trunk configuration?
    1. Ashow vlan brief
    2. Bshow interfaces type/number switchport
    3. Cshow interface trunk
    4. DNone of the above
  8. 8Which three are ways to protect unused switch ports?
    1. AEnter the switchport mode trunk command on each interface
    2. BEnter the switchport mode access command on each interface.
    3. CPlace each unused port in a VLAN that does not exist, is inactive, or is connected to limited resources.
    4. DPlace each unused port in a VLAN 1.
    5. EDisable each unused interface using the shutdown command.
  9. 9Which is not a secure MAC address learning for port security?
    1. ASticky method
    2. BRestrict method
    3. CDynamic method
    4. DStatic method
  10. 10If port security is configured, by default what is the result if a security violation occurs?
    1. AIt goes into Restrict mode until an admin resets it.
    2. BIt goes into Restrict mode, denying unsecured MAC addresses but allowing secured MAC addresses.
    3. CIt goes into Shutdown mode for five minutes (300 seconds) and then resets.
    4. DIt goes into Shutdown mode until an admin resets it.
    5. ENone of the above.

Información

Descripción
CCENT Information System Test sobre Ch. 7 Study Exam, creado por Darion Ward el 16/05/2017.
Idioma
English
Visitas
4
Etiquetas
information systemccent
Valoración
Aún sin valoraciones
Valora este test
Valora este test

Más sobre VLANs

Escríbenos

¿Sobre qué es tu mensaje?

¿Qué deberíamos añadir?