Test
6707- 216 Applying paint systems by brush and roller to complex areas practice test
Crea una cuenta gratis para terminar este test
Guarda tu progreso y consulta tu resultado final.
¿Ya tienes cuenta? Inicia sesión
Preguntas del test (25)
1Which one of the following items will require special attention when using a steam
stripper in a domestic environment?- Aa Television.
- Bb Desk.
- Cc Kettle.
- Dd Radiator.
2Plastic sheeting is sometimes placed under cotton dust sheets when protecting furniture.
Why is this?- Aa To protect the plastic sheeting.
- Bb To prevent dust from transferring through.
- Cc To prevent the sheets from slipping off.
- Dd To save on the use of cotton sheets.
3Due to its lightness, which one of the following is generally the best sheeting for
covering office equipment?- Aa Tarpaulin.
- Bb Plastic sheet.
- Cc Adhesive plastic.
- Dd Cotton twill.
4Which one of the following tapes would be the most suitable for masking a previously
painted surface?- Aa Low tack tape.
- Bb Duct tape.
- Cc Masking tape.
- Dd Insulation tape.
5Which one of the following identifies the best reason for carefully removing masking tape
after the painting has been completed?- Aa To save time cleaning up.
- Bb To allow the paint to flow.
- Cc To re-use the masking tape.
- Dd To stop paint being lifted off.
6Which one of the following is the most important reason for professionally cleaning dust
sheeting after use?- Aa To prevent cross-contamination.
- Bb To ensure a professional image.
- Cc To remove insects.
- Dd To remove old paint.
7Which of the following component parts of a brush is used to bind the setting to the
handle?- Aa Ferrule.
- Bb Stock.
- Cc Frame.
- Dd Filling
8A short pile Mohair roller is unsuitable for applying emulsion to an embossed surface
because the- Aa roller would over fill the surface
- Bb mohair would come away
- Cc roller would skim over the surface
- Dd rolling would take too long.
9A water-borne gloss is being applied to a window cill. Why might a synthetic filament
brush be used specifically for this task?- Aa The filament is easier to clean after use.
- Bb The brush marks produce a good texture.
- Cc The filament brush is cheaper.
- Dd The brush marks are less visible.
10Which one of the following defects may occur if a tin of solvent-borne undercoat paint is
not prepared before use?- Aa Delayed drying time.
- Bb Increased odour.
- Cc Blooming.
- Dd Cissing.
11Which one of the following surface coatings allows timber to ‘breathe’?
- Aa Gloss paint.
- Bb Eggshell paint.
- Cc Silk-emulsion paint.
- Dd Micro-porous paint.
12Which one of the following paint types would not be stirred prior to use?
- Aa Gloss.
- Bb Thixotropic.
- Cc Silk-emulsion.
- Dd Micro-porous.
13What evaporates when an aluminium primer dries?
- Aa Cellulose thinner.
- Bb Methylated spirit.
- Cc Distilled water.
- Dd White spirit.
14A common problem associated with gloss paint drying in hot and dry conditions is
- Aa rapid drying
- Bb loss of gloss
- Cc cissing
- Dd crazing
15The first component of a panelled door to be painted is the
- Aa stiles
- Bb rails
- Cc muntins
- Dd mouldings.
16If gloss is applied on top of an undercoat of the wrong colour, which defect is likely
to occur?- Aa Grinning.
- Bb Flashing.
- Cc Bleeding.
- Dd Bleaching.
17Careless application of solvent-borne gloss by roller can cause which of the following
defects?- Aa Blooming.
- Bb Cissing.
- Cc Crazing.
- Dd Skid marks.
18Strongly coloured painted surfaces exposed to direct sunlight over time may experience
- Aa bleeding
- Bb flaking
- Cc fading
- Dd cissing.
19If a surface is described as ‘friable’, it would appear
- Aa flaking/crumbling and dry
- Bb wet/damp and mouldy
- Cc soapy and white
- Dd as dry powder crystals.
20A synthetic filament brush has been used with water-borne gloss paint. Which one of the
following cleaning methods should be used?- Aa Remove excess paint, wash in sugar soap.
- Bb Remove excess paint, wash in methylated spirit.
- Cc Remove excess paint, wash in water.
- Dd Remove excess paint, wash in solvent.
21How should roller sleeves be stored after cleaning and drying?
- Aa Laid flat in a dry place.
- Bb Placed upright in a dry place.
- Cc Suspended upright in water.
- Dd Laid, submerged in water.
22How should materials with low ‘flash points’ be stored?
- Aa Away from other paints.
- Bb At specific temperatures.
- Cc Stored outside only.
- Dd In direct sunlight.
23An important reason for stock rotation is to
- Aa prevent stock from degrading
- Bb ensure that recent stock is used first
- Cc get the best value from bargain prices
- Dd minimise the theft of materials.
24Why does paint sometimes ‘skin’ after use?
- Aa Because the solvent evaporates and the surface drys.
- Bb Because the oil has leaked from the bottom of the tin.
- Cc Due to inappropriate stirring after use.
- Dd Due to an incorrect storage temperature.
25When the components of paint separate in the tin, this is known as
- Aa crazing
- Bb blooming
- Cc cissing
- Dd settling.
Información
- Descripción
- 6707- 216 Applying paint systems by brush and roller to complex areas
- Autor
- james crowley
- Idioma
- English
- Visitas
- 1.109
- Valoración
- Aún sin valoraciones Valora este test