Quiz
6707- 216 Applying paint systems by brush and roller to complex areas practice test
Create a free account to finish this quiz
Save your progress and see your final score.
Already have an account? Sign in
Questions in this quiz (25)
1Which one of the following items will require special attention when using a steam
stripper in a domestic environment?- Aa Television.
- Bb Desk.
- Cc Kettle.
- Dd Radiator.
2Plastic sheeting is sometimes placed under cotton dust sheets when protecting furniture.
Why is this?- Aa To protect the plastic sheeting.
- Bb To prevent dust from transferring through.
- Cc To prevent the sheets from slipping off.
- Dd To save on the use of cotton sheets.
3Due to its lightness, which one of the following is generally the best sheeting for
covering office equipment?- Aa Tarpaulin.
- Bb Plastic sheet.
- Cc Adhesive plastic.
- Dd Cotton twill.
4Which one of the following tapes would be the most suitable for masking a previously
painted surface?- Aa Low tack tape.
- Bb Duct tape.
- Cc Masking tape.
- Dd Insulation tape.
5Which one of the following identifies the best reason for carefully removing masking tape
after the painting has been completed?- Aa To save time cleaning up.
- Bb To allow the paint to flow.
- Cc To re-use the masking tape.
- Dd To stop paint being lifted off.
6Which one of the following is the most important reason for professionally cleaning dust
sheeting after use?- Aa To prevent cross-contamination.
- Bb To ensure a professional image.
- Cc To remove insects.
- Dd To remove old paint.
7Which of the following component parts of a brush is used to bind the setting to the
handle?- Aa Ferrule.
- Bb Stock.
- Cc Frame.
- Dd Filling
8A short pile Mohair roller is unsuitable for applying emulsion to an embossed surface
because the- Aa roller would over fill the surface
- Bb mohair would come away
- Cc roller would skim over the surface
- Dd rolling would take too long.
9A water-borne gloss is being applied to a window cill. Why might a synthetic filament
brush be used specifically for this task?- Aa The filament is easier to clean after use.
- Bb The brush marks produce a good texture.
- Cc The filament brush is cheaper.
- Dd The brush marks are less visible.
10Which one of the following defects may occur if a tin of solvent-borne undercoat paint is
not prepared before use?- Aa Delayed drying time.
- Bb Increased odour.
- Cc Blooming.
- Dd Cissing.
11Which one of the following surface coatings allows timber to ‘breathe’?
- Aa Gloss paint.
- Bb Eggshell paint.
- Cc Silk-emulsion paint.
- Dd Micro-porous paint.
12Which one of the following paint types would not be stirred prior to use?
- Aa Gloss.
- Bb Thixotropic.
- Cc Silk-emulsion.
- Dd Micro-porous.
13What evaporates when an aluminium primer dries?
- Aa Cellulose thinner.
- Bb Methylated spirit.
- Cc Distilled water.
- Dd White spirit.
14A common problem associated with gloss paint drying in hot and dry conditions is
- Aa rapid drying
- Bb loss of gloss
- Cc cissing
- Dd crazing
15The first component of a panelled door to be painted is the
- Aa stiles
- Bb rails
- Cc muntins
- Dd mouldings.
16If gloss is applied on top of an undercoat of the wrong colour, which defect is likely
to occur?- Aa Grinning.
- Bb Flashing.
- Cc Bleeding.
- Dd Bleaching.
17Careless application of solvent-borne gloss by roller can cause which of the following
defects?- Aa Blooming.
- Bb Cissing.
- Cc Crazing.
- Dd Skid marks.
18Strongly coloured painted surfaces exposed to direct sunlight over time may experience
- Aa bleeding
- Bb flaking
- Cc fading
- Dd cissing.
19If a surface is described as ‘friable’, it would appear
- Aa flaking/crumbling and dry
- Bb wet/damp and mouldy
- Cc soapy and white
- Dd as dry powder crystals.
20A synthetic filament brush has been used with water-borne gloss paint. Which one of the
following cleaning methods should be used?- Aa Remove excess paint, wash in sugar soap.
- Bb Remove excess paint, wash in methylated spirit.
- Cc Remove excess paint, wash in water.
- Dd Remove excess paint, wash in solvent.
21How should roller sleeves be stored after cleaning and drying?
- Aa Laid flat in a dry place.
- Bb Placed upright in a dry place.
- Cc Suspended upright in water.
- Dd Laid, submerged in water.
22How should materials with low ‘flash points’ be stored?
- Aa Away from other paints.
- Bb At specific temperatures.
- Cc Stored outside only.
- Dd In direct sunlight.
23An important reason for stock rotation is to
- Aa prevent stock from degrading
- Bb ensure that recent stock is used first
- Cc get the best value from bargain prices
- Dd minimise the theft of materials.
24Why does paint sometimes ‘skin’ after use?
- Aa Because the solvent evaporates and the surface drys.
- Bb Because the oil has leaked from the bottom of the tin.
- Cc Due to inappropriate stirring after use.
- Dd Due to an incorrect storage temperature.
25When the components of paint separate in the tin, this is known as
- Aa crazing
- Bb blooming
- Cc cissing
- Dd settling.
Information
- Description
- 6707- 216 Applying paint systems by brush and roller to complex areas
- Author
- james crowley
- Language
- English
- Views
- 1,109
- Rating
- No ratings yet Rate this quiz