Archer

An Archer Shooting technique and form The standard convention on teaching archery, is to hold the bow depending upon eye dominance (though in modern Kyudoall archers are trained to hold the bow in the right hand). Therefore, if you were right eye dominant, you would hold the bow in the left hand, and draw the string with the right hand. Not everybody agrees with this line of thought, though. A smoother, and more fluid release of the string produces the finest and most consistently repeatable shots, and therefore determines the accuracy of the arrow flight. There are some who believe that the hand with the greatest dexterity, should be the hand that draws and releases the string. Either eye can be used for aiming, and even the less dominant eye can be trained over time to effectively become the more dominant. This can be achieved by retraining with the use of an eye-patch over the dominant eye as a temporary measure. Medieval archery reenactment The hand that holds the bow is referred to as the bow hand and its arm the bow arm. The opposite hand is called thedrawing hand or string hand. Terms such as bow shoulder or string elbow follow the same convention.If shooting according to eye dominance, then right-eye-dominant archers, shooting in a conventional way, will hold the bow with their left hand.If shooting according to hand dexterity, then the string will be drawn with whichever hand possesses the greatest dexterity, regardless of eye dominance. Modern form[edit] To shoot an arrow, an archer first assumes the correct stance. The body should be at or nearly perpendicular to the target and the shooting line, with the feet placed shoulder-width apart. As an archer progresses from beginner to a more advanced level other stances such as the "open stance" or the "closed stance" may be used, although many choose to stick with a "neutral stance". Each archer will have a particular preference but mostly this term indicates that the leg furthest from the shooting line will be a half to a whole foot-length from the other foot, on the ground.To load, the bow is pointed toward the ground, tipped slightly clockwise of vertical (for a right handed shooter) and the shaft of the arrow is placed on the arrow rest or shelf. The back of the arrow is attached to the bowstring with the nock (a small locking groove located at the proximal end of the arrow). This step is called "nocking the arrow". Typical arrows with three vanes should be oriented such that a single vane, the "cock feather", is pointing away from the bow, to improve the clearance of the arrow as it passes the arrow rest.A compound bow is fitted with a special type of arrow rest, known as a launcher, and the arrow is usually loaded with the cock feather/vane pointed either up, or down, depending upon the type of launcher being used.The bowstring and arrow are held with three fingers, or with a mechanical arrow release. Most commonly, for finger shooters, the index finger is placed above the arrow and the next two fingers below, although several other techniques have their adherents around the world, involving three fingers below the arrow, or an arrow pinching technique. Instinctive shooting is a technique eschewing sights and is often preferred by traditional archers (shooters of longbows and recurves). In either the split finger or three finger under case, the string is usually placed in either the first or second joint of the fingers.Another type of string hold, used on traditional bows, is the type favoured by the Mongol warriors, known as the "thumb release", style. This involves using the thumb to draw the string, with the fingers curling around the thumb to add some support. To release the string, the fingers are opened out and the thumb relaxes to allow the string to slide off the thumb. When using this type of release, the arrow should rest on the same side of the bow as the drawing hand i.e. Left hand draw = arrow on left side of bow.The bow is then raised and drawn, with varying alignments used for vertical versus slightly canted bow positions. This is often one fluid motion for shooters of recurves and longbows which tends to vary from archer to archer, although for a compound shooter, there is often a slightly-jerky movement occurring during the drawback of the arrow at around midpoint where the draw weight is at its maximum, before relaxing into a comfortable stable full draw position. The string hand is drawn towards the face, where it should rest lightly at the chosen fixed anchor point. This point is consistent from shot to shot and is usually at the corner of the mouth, on the chin, to the cheek, or to the ear, depending upon one's preferred shooting style. The bow arm is held outwards toward the target. The elbow of this arm should be rotated so that the inner elbow is perpendicular to the ground, though archers with hyper extendable elbows tend to angle the inner elbow toward the ground as exemplified by the Korean archer Jang Yong-Ho. This keeps the forearm out of the way of the bowstring.In modern form, the archer stands erect, forming a "T". The archer's lower trapezius muscles are used to pull the arrow to the anchor point. Some modern bows will be equipped with a mechanical device, called a clicker, which produces a clicking sound when the archer reaches the correct draw length. In contrast, traditional English Longbow shooters step "into the bow", exerting force with both the bow arm and the string hand arm simultaneously, especially when using bows having draw weights from 100 lbs to over 175 lbs. Heavily-stacked traditional bows (recurves, long bows, and the like) are released immediately upon reaching full draw at maximum weight, whereas compound bows reach their maximum weight in or around mid-draw, dropping holding weight significantly at full draw. Compound bows are often held at full draw for a short time to achieve maximum accuracy.The arrow is typically released by relaxing the fingers of the drawing hand (see Bow draw), or triggering the mechanical release aid. Usually the release aims to keep the drawing arm rigid, the bow hand relaxed, and the arrow is moved back using the back muscles, as opposed to using just arm motions. An archer should also pay attention to the recoil or follow through of his or her body, as it may indicate problems with form (technique) that affect accuracy. Protective equipment Main articles: Bracer, Finger tab and Thumb ring A right-hand finger tab to protect the hand while the string is drawn. Most archers wear a bracer (also known as an arm-guard) to protect the inside of the bow arm from being hit by the string and prevent clothing from catching the bow string. The bracer does not brace the arm; the word comes from the armoury term "brassard", meaning an armoured sleeve or badge. The Navajo people have developed highly ornamented bracers as non-functional items of adornment.[27] Some archers (mostly women) also wear protection on their chests, called chestguards or plastrons. The myth of the Amazons was that they had one breast removed to solve this problem.[28] Roger Aschammentions one archer, presumably with an unusual shooting style, who wore a leather guard for his face.[29]The drawing digits are normally protected by a leather tab, glove, or thumb ring. A simple tab of leather is commonly used, as is a skeleton glove. Medieval Europeans probably used a complete leather glove.[30]Eurasiatic archers who used the thumb or Mongolian draw protected their thumbs, usually with leather according to the author of Arab Archery,[31] but also with special rings of various hard materials. Many surviving Turkish and Chinese examples are works of considerable art. Some are so highly ornamented that the users could not have used them to loose an arrow. Possibly these were items of personal adornment, and hence value, remaining extant whilst leather had virtually no intrinsic value and would also deteriorate with time. In traditional Japanese archery a special glove is used, provided with a ridge which is used to draw the string.[32]

Types of bows Main article: Bow and arrowWhile there is great variety in the construction details of bows (both historic and modern), all bows consist of a string attached to elastic limbs that store mechanical energy imparted by the user drawing the string. Bows may be broadly split into two categories: those drawn by pulling the string directly and those that use a mechanism to pull the string.Directly drawn bows may be further divided based upon differences in the method of limb construction, notable examples being self bows, laminated bows andcomposite bows. Bows can also be classified by the bow shape of the limbs when unstrung; in contrast to simple straight bows, a recurve bow has tips that curve away from the archer when the bow is unstrung. The cross-section of the limb also varies; the classic longbow is a tall bow with narrow limbs that are D-shaped in cross section, and the flatbow has flat wide limbs that are approximately rectangular in cross-section. The classic D-shape comes from the use of the wood of the yew tree. The sap-wood is best suited to the tension on the back of the bow, and the heart-wood to the compression on the belly. Hence, a cross-section of a yew longbow shows the narrow, light-coloured sap-wood on the 'straight' part of the D, and the red/orange heartwood forms the curved part of the D, to balance the mechanical tension/compression stress. Cable-backed bows use cords as the back of the bow; the draw weight of the bow can be adjusted by changing the tension of the cable. They were widespread among Inuit who lacked easy access to good bow wood. One variety of cable-backed bow is the Penobscot bow or Wabenakibow, invented by Frank Loring (Chief Big Thunder) about 1900.[24] It consists of a small bow attached by cables on the back of a larger main bow.Modern recurve bow (Takedown)Compound bows are designed to reduce the force required to hold the string at full draw, hence allowing the archer more time to aim with less muscular stress. Most compound designs use cams or elliptical wheels on the ends of the limbs to achieve this. A typical let-off is anywhere from 65%–80%. For example, a 60-pound bow with 80% let-off will only require 12 pounds of force to hold at full draw. Up to 99% let-off is possible.[25] The compound bow was invented by Holless Wilbur Allenin the 1960s (a US patent was filed in 1966 and granted in 1969) and it has become the most widely used type of bow for all forms of archery in North America.Mechanically drawn bows typically have a stock or other mounting, such as the crossbow. They are not limited by the strength of a single archer and larger varieties have been used as siege engines.

New Page