Sem título

Start

mark out the required measurements of my product using a steel ruler,pencil and tri-square on the raw acrylic material

cut out the product design on the materials by using the scroll machine

shape the design on the materials by using the hand file and disc sander

is the design shape achieved?

is there any hole needing to be drill in a drill machine

remove the marks on the edges of the acrylic by using a hand file

are all the hard marks removed from the edges?

use the dry sandpaper to remove all the fine marks on the edges of the acrylic

are all the fine marks removed

are all the edges shined

is there any section requiring to be bent using the a strip heater

polish the edges of the acrylics to shine on a buffing machine

drill the hole on the materials on the drilling machine and using the correct drill bit size

is drilling of the hole completed

the making on this part of the artefact is done

end