Sem título

START

Mark out The needed measurement of my design by using steel ruler, pencil and tri- square on raw acrylic

Use scroll machine to cut out the planned design on the material

Use hand file and disc sander machine to shape the desiign

is the expected design obtained?

Should there be any hole drilled on the material?

YES

NO

Use hand file to remove the marks on the edges of the acrylic material

NO

Have all the marks been removed?

NO

Use correct drill bit size and drill hole on the acrylic material using drill machine

YES

Remove all the fine marks on the edges of acrylic by using dry and wet paper

YES

Is the drilling of the hole done?

YES

NO

Have all the fine marks been removed?

NO

Use buffing machine to shine the edges by polishing

are all the edges shined?

NO

Is there any part need to be bent using a strip heater?

YES

Soft and bend the section/part on the acrylic material using strip heater

Is the bending done correctly?

NO

Making of the acrylic piece is done.

END