Mapa mental
Physical Landforms

Conteúdo do mapa
Physical Landforms
Rivers
- Valley and Channel Shape
- Are formed as the river flows downhill.
- The shape of the valley changes along the river depending on whether erosion or deposition is having the most impact.
- At the upper course there is a V - shaped valley and a narrow, shallow channel.
- At the middle course there is gently sloping valley sides and a wider, deeper channel.
- At the lower course there is a very wide, almost flat valley and a very wide, deep channel.
- Vertical Erosion
- Deepens the river valley and channel making it V - shaped.
- It is dominant in the upper course of the river.
- High turbulence causes the rough, angular particles to be scraped along the river bed, causing intense downwards erosion.
- Lateral Erosion
- This widens the river valley and channel during the formation of meanders.
- It is dominant in the middle and lower courses.
- Waterfalls
- Form where a river flows over an area of hard rock followed by an area of softer rock.
- The softer rock is eroded more than the hard rock, creating a 'step' in the river.
- As water goes over the step it erodes more and more of the softer rock.
- A steep drop is eventually created, which is called a waterfall.
- Gorge
- The hard rock is eventually undercut by erosion. It becomes unsupported and collapses.
- The collapsed rocks are swirled around at the foot of the waterfall where they erode the softer rock by abrasion.
- This creates a deep plunge pool.
- Over time, more undercutting causes more collapses. The waterfall will retreat, leaving behind a steep - sided gorge.
- Interlocking Spurs
- In the upper course of a river most of the erosion is vertically downwards. This creates steep - sided, V -shaped valleys.
- The rivers aren't powerful enough to erode laterally - they have to wind around the high hillsides that stick out into their paths on either side.
- The hillsides that interlock with each other as the river winds around them are called interlocking spurs.
- Meanders
- The current is faster on the outside of the bend because the river channel is deeper ( there's less friction to slow the water down ).
- So more erosion takes place on the outside of the bend, forming river cliffs.
- The current is slower on the inside of the bend because the river channel is shallower ( there's more friction to slow the water down ).
- So eroded material is deposited on the inside of the bend, forming slip - off slopes.
- Oxbow lakes
- 1 - Erosion causes the outside bends to get closer.
- 2 - There's only a small bit of land left between the bends ( called the neck ).
- 3 - The river breaks through this land, usually during a flood and thhe river flows along the shortest course.
- Deposition eventually cuts off the meander forming an oxbow lake.
- Flood Plains
- Flat areas of land that flood.
- The flood plain is the wide valley floor on either side of a river which occasionally gets flooded.
- When a river floods onto the flood plain, the water slows down and deposits the eroded material that it's transporting.
- This builds up the flood plain ( makes it higher ).
- Meanders migrate across the flood plain, making it wider.
- The deposition that happens on the slip - off slopes of meanders also builds up the flood plain.
- Levees
- Levees are natural embankments along the edges of a river channel.
- During a flood, eroded material is deposited over the whole flood plain.
- The heaviest material is deposited closest to the river channel, because it gets dropped first when the river slows down.
- Over time, the deposited material builds up, creating levees along the edges of the channel.
- Are natural embankments.
- Estuaries
- Estuaries are tidal areas where the river meets the sea.
- Found at the mouth of a river, where it meets the sea. The land is close to sea level and the river valley is at its widest.
- The water here is tidal - the river level rises and falls each day.
- The water floods over the banks of the river carrying the silt and sand onto the valley floor.
- As the tide reaches its highest point, the water is moving very slowly so the sediment is deposited.
- Over time, more and more mud builds up, creating large areas of mudflats.
- At low tide, the wide, muddy banks are exposed.
- Valley and Channel Shape
Erosion
- Hydraulic Action
- The force of the water breaks rock particles away from the river channel.
- Solution
- River water dissolves some types of rock, e.g. chalk and limestone.
- Abrasion
- Eroded rocks picked up by the river scrape and rub against the channel, wearing it away. Most erosion happens by abrasion.
- Attrition
- Eroded rocks picked up by the river smash into each other and break into smaller fragments. Their edges also get rounded off as they rub together. The further material travels, the more eroded it gets - attrition causes particle size to decrease between a river's source and its mouth.
- Hydraulic Action
Transportation
- Traction
- Large particles like boulders are pushed along the river bed by the force of the water.
- Suspension
- Small particles like silt and clay are carried along by the water.
- Saltation
- Pebble - sized particles are bounced along the river bed by the force of water.
- Solution
- Soluble materials dissolve in the water and are carried along.
- Traction
Imagens e arquivos do mapa
Informações
- Descrição
- Year 11 Geography Mapa Mental sobre Physical Landforms, criado por Cleo Watson em 28-11-2017.
- Criado por
- Cleo Watson
- Visualizações
- 1
- Avaliação





