Ajude a dar forma ao GoConqr. O que a gente deve adicionar?

Mapa mental

2.1.e Implement and troubleshoot EtherChannel

flplira Inglês

Conteúdo do mapa

2.1.e Implement and troubleshoot EtherChannel

  1. 2.1.e [iv] Etherchannel misconfiguration guard

    • EtherChannel guard to detect an EtherChannel misconfiguration if your switch is running PVST +, rapid PVST +, or MSTP.
    • EtherChannel guard places the switch interfaces in the error-disabled state
  2. 2.1.e [ii] Layer 2, layer 3

    • channel-group channel-group-number mode {auto [non-silent] | desirable [non-silent] | on} | {active | passive}
    • interface port-channel port-channel-number
  3. 2.1.e [i] LACP, PAgP, manual (ON)

    • LACP (802.3ad)
      • Passive
      • Active
    • PAgP
      • Desirable
      • Auto
  4. 2.1.e [iii] Load-balancing

    • port-channel load-balance {dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac}
    • src-dst-mixed-ip-port vlan included mpls label-ip
  5. Cisco switches support max 64 EtherChannels

  6. Same speed and duplex settings. Same operating mode (trunk, access, dynamic). If not trunking, same access VLAN. If trunking, same trunk type, allowed VLANs, and native VLAN. On a single switch, each port in a Port-channel must have the same STP cost per VLAN on all links in the Port-channel. No ports can have SPAN configured.

Informações

Descrição
Mapa Mental sobre 2.1.e Implement and troubleshoot EtherChannel, criado por flplira em 28-08-2015.
Criado por
flplira
Visualizações
2
Avaliação

Mais sobre EtherChannel and Link Aggregation

Fale Conosco

Sobre o que é sua mensagem?

O que a gente deve adicionar?