CAD 1203 Chapter 3

1. 1The unit used to specify capacitance is _____________?

   1. AOhms
   2. BHenries
   3. CFarads
   4. DJoules
2. 2The unit used to specify inductance is ________?

   1. AOhms
   2. BHenries
   3. CFarads
   4. DJoules
3. 3Which of the following components is used to step up or step down voltage?

   1. ASwitch
   2. BDiode
   3. CTransformer
   4. DCapacitor
4. 4The designation L3 on a schematic would be associated with which of the following components?

   1. AResistor
   2. BInductor
   3. CCapacitor
   4. DNone of the above
5. 5The designation R1 on a schematic would be associated with which of the following components?

   1. AResistor
   2. BCapacitor
   3. CTransformer
   4. DInductor
6. 6How are lines on a schematic that cross and are not connected electrically shown?

   1. AWith a large circle at the point of intersection
   2. BWith a cross at the point of intersection
   3. CWith a large dot
   4. DNone of the above
7. 7Which of the following components is considered an active component?

   1. AResistor
   2. BInductor
   3. CDiode
   4. DRheostat
8. 8Which of the following components is used to prevent overload conditions and is destroyed in the process?

   1. ACircuit breaker
   2. BFuse
   3. CDiode
   4. DTransformer
9. 9A rheostat is a form of ________?

   1. AResistor
   2. BCapacitor
   3. CInductor
   4. DTransformer
10. 10What would a large dot located at the point where two lines intersect on a schematic would indicate?

    1. AThe lines are electrically connected
    2. BThe line are not electrically connected
    3. CInstrumentation will be located at that point
    4. DNone of the above

Descrição

Quiz sobre CAD 1203 Chapter 3, criado por Cetla Ivcc em 04-03-2015.

Autor

Cetla Ivcc

Idioma

English

Visualizações

0

Avaliação

Ainda sem avaliações

Avalie este quiz

Avalie este quiz

Mais sobre Circuit Symbols