Gestalte GoConqr mit. Was sollen wir als Nächstes hinzufügen?

Mindmap

2.1.e Implement and troubleshoot EtherChannel

flplira Englisch

Inhalt der Mindmap

2.1.e Implement and troubleshoot EtherChannel

  1. 2.1.e [iv] Etherchannel misconfiguration guard

    • EtherChannel guard to detect an EtherChannel misconfiguration if your switch is running PVST +, rapid PVST +, or MSTP.
    • EtherChannel guard places the switch interfaces in the error-disabled state
  2. 2.1.e [ii] Layer 2, layer 3

    • channel-group channel-group-number mode {auto [non-silent] | desirable [non-silent] | on} | {active | passive}
    • interface port-channel port-channel-number
  3. 2.1.e [i] LACP, PAgP, manual (ON)

    • LACP (802.3ad)
      • Passive
      • Active
    • PAgP
      • Desirable
      • Auto
  4. 2.1.e [iii] Load-balancing

    • port-channel load-balance {dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac}
    • src-dst-mixed-ip-port vlan included mpls label-ip
  5. Cisco switches support max 64 EtherChannels

  6. Same speed and duplex settings. Same operating mode (trunk, access, dynamic). If not trunking, same access VLAN. If trunking, same trunk type, allowed VLANs, and native VLAN. On a single switch, each port in a Port-channel must have the same STP cost per VLAN on all links in the Port-channel. No ports can have SPAN configured.

Informationen

Beschreibung
Mindmap am 2.1.e Implement and troubleshoot EtherChannel, erstellt von flplira am 28/08/2015.
Erstellt von
flplira
Aufrufe
2
Bewertung

Mehr zu EtherChannel and Link Aggregation

Feedback

Worum geht es?

Was sollen wir als Nächstes hinzufügen?