Mind map
2.1.e Implement and troubleshoot EtherChannel
Map content
2.1.e Implement and troubleshoot EtherChannel
2.1.e [iv] Etherchannel misconfiguration guard
- EtherChannel guard to detect an EtherChannel misconfiguration if your switch is running PVST +, rapid PVST +, or MSTP.
- EtherChannel guard places the switch interfaces in the error-disabled state
2.1.e [ii] Layer 2, layer 3
- channel-group channel-group-number mode {auto [non-silent] | desirable [non-silent] | on} | {active | passive}
- interface port-channel port-channel-number
2.1.e [i] LACP, PAgP, manual (ON)
- LACP (802.3ad)
- Passive
- Active
- PAgP
- Desirable
- Auto
- LACP (802.3ad)
2.1.e [iii] Load-balancing
- port-channel load-balance {dst-ip | dst-mac | src-dst-ip | src-dst-mac | src-ip | src-mac}
- src-dst-mixed-ip-port vlan included mpls label-ip
Cisco switches support max 64 EtherChannels
Same speed and duplex settings. Same operating mode (trunk, access, dynamic). If not trunking, same access VLAN. If trunking, same trunk type, allowed VLANs, and native VLAN. On a single switch, each port in a Port-channel must have the same STP cost per VLAN on all links in the Port-channel. No ports can have SPAN configured.
Information
- Description
- Mind Map on 2.1.e Implement and troubleshoot EtherChannel, created by flplira on 28/08/2015.
- Created by
- flplira
- Views
- 2
- Rating
More on EtherChannel and Link Aggregation