Quiz
Mod 4
Create a free account to finish this quiz
Save your progress and see your final score.
Already have an account? Sign in
Questions in this quiz (35)
1A diode which emits photons when conducting is a
- Azener
- Blight emitting
- Cvaractor
2A junction diode
- Acan handle only very small currents
- Bis similar to a vacuum diode but cannot rectify
- Chas one p-n junction
3What diode gives off light photons when forward biased
- AShottky diode
- BGunn diode
- CLED
4When testing the forward bias of a diode with a mulitmeter
- Athe positive lead of the ohmmeter is placed on the anode
- Bit does not matter which terminal the postive lead
- Cthe positive lead of the ohmmeter is placed on the cathode
5A traic is a type of
- Atransistor
- Bthyristor
- Cthermistor
6what gives the color of an LED
- Athe active element
- Bthe type of gas used inside it
- Cthe plastic is encased in
7the electrodes of a silicon controlled rectifer (SCR) are
- Aanode, cathode ,source
- Bgate< cathode, anode
- Csource, drain, gate
8"P' Type materials are
- Adonors
- Bconductors
- Cacceptors
9A bi-directional TRIAC has two silicon controlled rectifier(SCR)s connected in
- Ainverse parallel
- Bseries parallel
- Cparallel series
10A germanium diode...
- Ahas a higher forward bias voltage than a silicon diode
- Bhas the same forward bias voltage as a silicon diode
- Chas a lower forward bias voltage than a silicon diode
11A Zener diode is used across the output for a power supply circuit to...
- Agive a full wave rectification
- Bprevent thermal runway
- Cprovide a steady DC voltage output without falling
12What is an intrinsic material?
- AA pure material
- BOne with removed elements
- COne with added elements
13A FET when compared to a junction transistor is
- Alow impedance
- Bhigh impedance
- Ccurrent operated
14A transistor at saturation has...
- Ahigh resistance
- Blow resistance
- Czero resistance
15How do you increase voltage gain of an amplifier?
- Adecrease base circuit bias
- Bdecrease input resistance
- Cincrease input resistance
16How is a push-pull transistor arrangement connected?
- Aemitter to emitter
- Bbase to base
- Ccollector to collector
17In a Common Emitter Amplifier RE (Emitter Resistor) is used for...
- Astabilisation
- Bload control
- Cbiasingg
18In an electronic circuit with an operational amplifier connected in the push-pull configuration, the circuit...
- Ablocks half of the input signal
- Bdecreases impedance
- Cutilizes both sides of the input signal
19The common collector amplifier is sometimes called the emitter follower circuit because...
- Athe emitter voltage follows the base voltage
- Bthe emitter voltage follows the collector voltage
- Cthe emitter current follows the collector current
20The emitter, base and collector currents follow ohm's and Kirchhoff's law which is...
- AIe = Ic - Ib
- BIe = Ib + Ic
- CIb = Ie + Ic
21A capacitor resistor coupled multistage amp lets...
- AAC pass only
- BDC pass only
- CAC and DC pass to the next stage
22What is the behaviour of an Op-amp when is acting as a Simple Voltage Comparator?
- AIt responds only to changes of input voltage
- BAct as a buffer amplifier
- CAs a two-state digital device with output voltage switching from high to low
23The input resistance to an inverting op-amp is 100 Ohms. The feedback resistance is 100 kilohms. What is the amplifier gain?
- A1/1000
- B1000
- C-1000
24The negative feedback for an integrator is connected across a...
- Ainductor
- Bcapacitor
- Cresistor
25Which mathematical operation is performed by a modulator amplifier?
- ASubtraction
- BAddition
- CMultiplication
26On a PCB, a decoupling capacitor is used to get rid of transient currents between which points?
- AInterspaced along the circuit
- BThe negative rail and the rest of the circuit
- CThe electronic circuit and the aircraft ground
27What are the basic criteria defining the PCB thickness board?
- AThe required strength and stiffness
- BThe required number of conducting paths
- CThe complexity of patterns and conducting paths
28A resolver synchro output is obtained from a rotor with...
- Athree coils at 120 to each other
- Bone single coil
- Ctwo coils at 90o to each other
29A two phase induction motor used in a servomechanism...
- Awill always require a starter
- Bis self starting under light loads
- Cruns with no slip
30An increase in amplitude of a rate feedback signal will cause...
- Ainstable operation
- Bsluggish servo operation
- Creduced hunting
31The result of reversing the rotor connections to the receiver of a torque synchro system is that the rotor position...
- Ais changed by 180
- Bis changed by 120
- Cis unchanged
32Digital signals vary...
- Ain discrete steps
- Bcontinuously between set levels
- Cslowly from one level to another level
33The rotor of a torque synchro indicator is...
- Ashort circuited
- Bconnected in series with the transmitter stator coil
- Csupplied with an excitation voltage
34In a Desynn indicator system, where is power supplied to?
- ATransmitter and indicator
- BTransmitter only
- CIndicator only
35The reference voltage in a differential transformer is applied to the winding(s) on...
- Aone of the outer limbs of the E-lamination
- Bthe center limb of the E-lamination
- Call three limbs of the E-laminations
Information
- Description
- Quiz on Mod 4, created by Matty alfalasi on 03/02/2019.
- Author
- Matty alfalasi
- Language
- English
- Views
- 64
- Rating
- No ratings yet Rate this quiz